air-jet loom

Weft Feeler Control System on Air-jet Loom

喷气织机探纬检测控制系统的研制

Improved Design about Air Cylinder Cam of Air-Jet Loom

喷气织机主气缸供气凸轮的改进设计

Reasonable processing parameters for the air jet loom production are proposed.

并以斜纹品种为例,给出了适合喷气织机生产的工艺参数.

An air-jet loom control system design based on ARM 7 was presented.

介绍了基于ARM7的喷气织机控制系统设计.

The dynamical balancing of beating up mechanism of air-jet loom is discussed.

探讨一种喷气织机四连杆打纬机构的动平衡方法.

The hardware aspect is about the main board based on Cortex-M3, power circuit board and drive board. The software aspect is mainly about using craft circle method to realize the weft control of air-loom using MDK software.

硬件主要是以Cortex-M3内核为中心的主板、电源板以及驱动板的设计；软件主要是利用MDK软件进行编程，采用工艺圆原理实现控制织机引纬的功能。

Air-jet loom is pivotal equipment in textile industry.

喷气织机是纺织行业的关键设备.

The Practice of Weaving Stretch Slubbed Fabric on Air-jet Loom

弹力竹节织物在喷气织机上的生产实践

Analyses and Treatment of JAT 600A Air-jet Loom Weft Stoppage Reasons

JAT600A型喷气织机纬停原因分析与处理

The Watt six-bar mechanism has been widely adopted as the beating up mechanism of air-jet loom.

喷气织机打纬机构广泛采用瓦特型六 连杆机构.

Raising Operation Efficiency of JAT 600A-19O Air-jet Loom

提高JAT600A-190型喷气织机效率的探讨

The present situation and existing problems of-made air-jet loom were summarized and analysed.

总结目前国产喷气织机的现状及对存在的问题分析原因.

Weaving satin furniture fabric in broad two-beam air-jet loom, the problems of center gap and left& right color difference are existing.

宽幅喷气织机双织轴织造缎纹类家纺织物时，经常出现中缝及左右布面色差问题，为此，在整经工序要确保片纱张力一致和各经轴间经纱张力一致；

Practice of Cross Weaving Cotton/ Polyamide Monofilament Fabric on Air-jet Loom

喷气织机制织棉锦单丝交织面料的生产实践

Influence Factor and Control Method of Warp Hairiness of Air-jet Loom

影响喷气织机经纱毛羽的因素与控制措施

Weaving Technology of "Striped Plain" with Compound Tappet on Air-jet Loom

喷气织机采用组合踏盘生产牙签条的研究利用组合踏盘织造灯芯条织物

The principle of a new type of the air jet loom controlling system is described.

论述了喷气织机的一种新型控制系统原理.

The Air Loom Control System Based on ARM7 Embedded System

基于arm7的嵌入式系统在喷气织机控制技术中的应用

To produce join stitch fabric which is combined plain weave with stain in single loom bean air-jet loom, higher demand for yarn strength and evenness CV were proposed.

为了在单织轴喷气织机上顺利生产平纹加缎纹条联合组织织物，对纱线的强力、条干CV等方面提出了更高的要求。

Some corresponding measures should be adopted on special loom for weaving air bag.

同时,气囊专用织机亦应采取相应的技术措施.