bearing replacement

Study on Bearing Replacement Method for Precast Packaged Type Simple-supported Bridges

预制装配式简支梁桥支座更换设计方法

Replacement of the Elastic Oil Tank of Thrust Bearing of No.1 Generator in Danjiangkou Hydroelectric Power Plant

丹江电厂发电机推力轴承弹性油箱更换陕北石油秩序

Test Study on the New Method of Bearing Replacement of Simple Support-Continuous Girder Bridge

简支变连续梁桥支座更换新方法的试验研究

Two bearing replacement programs were compared after analysis, including the symmetric fixed support program on the2nd pier and the non-symmetric fixed support program on the3rd pier.

分析比选了两种支座更换布置方案：对称的2号墩固定支座方案和非对称的3号墩固定支座方案。

To be Applied by the Be Ultra-thin Hoisting Jack in the Bearing of Bridge Replacement or Whole goes Against Rises in the Construction

超薄千斤顶在桥梁支座更换整体顶升施工中的应用

According to calculation result, the design for the hydrostatic bearing system and the replacement of oil-infused sliding bearing with hydrostatic bearing is achieved.

根据计算结果已成功完成静压轴承系统设计和浇油润滑的滑动轴承到静压轴承改造。

A poor designed bearing lubricating system for the conveyer roller bed of the continuous casting unit at SISG caused a frequent replacement of the bearings and bearing brackets.

韶钢第二炼钢厂连铸机输送辊道轴承润滑系统设计不合理导至运行中轴承和轴承座的频繁更换。

Replacement inside the Tunnel and Failure Analysis of Sealing of TBM Main Bearing

TBM主轴承内密封洞内更换及失效分析

The power-saving way of the three-phase alternating current asynchronous motor was discussed on several respects of the control of optimal bearing power, replacement of old motor, control the end point voltage of motor and control of the rotation speed of motor.

本文从最佳负载率的控制、更换老旧电动机、调节电动机端电压、控制电动机转速等几个方面浅谈三相交流异步电动机的节电途径。

Considering the difficulty of bearing replacements for bridges, bearing replacement is taken into account in the designing of precast packaged type simple-supported bridges in this paper.

针对预制装配式简支梁桥，考虑到今后支座更换操纵空间的问题，在设计阶段，将支座更换纳入设计范畴。