hydrogenerator

Superharmonic and Subharmonic Resonances of Hydrogenerator Rotors Caused by Unbalanced Magnetic Pull

不平衡磁拉力引起水轮发电机转子的超/次谐波共振

This article analysis machining character of the generator, adopting new technology, meeting the requirement of the designing, accumulating experience for the machining of the horizontal hydrogenerator.

本文分析了该发电机制造特点，采用新的工艺，满足了设计要求，为卧式水轮发电机的制造积累了经验。

The Lubrication Calculation of Thrust Bearing With Pivoted Supports for Hydrogenerator

水轮发电机托瓦支撑推力轴承的润滑计算

The paper gives a brief introduction of the stator winding installation of the first ALSTOM hydrogenerator ( unit 5).

本文主要介绍三峡首台ALSTOM水轮发电机组（5机）定子绕组安装工艺。

Analysis of Vibration Mode and Response for Hydrogenerator Lower Bracket

水轮发电机下机架振动模态和径向谐响应分析

This paper briefly introduces the main features and structure of the hydrogenerator for Lianhua power station.

简要介绍了莲花电站水轮发电机的基本特性及结构特点。

This standard is applicable to ordering, manufacturing and inspection of hydrogenerator rotating plate forgings.

本标准适用于水轮发电机镜板锻件的订货 、 制造和检验.

The Solution on Exceeding Admissible Limit of the Upper-guide Bearing Runout of Hydrogenerator Unit 2# for Shiquan Hydropower Station

石泉2号水轮发电机上导摆度超标处理

A Research for Adjusting Method of Gap at Guide Bearing with Support Pin of Spherical End in Hydrogenerator

水轮发电机球面支柱式导轴承瓦间隙调整方法的研究

Analysis and Comparison of Four Transposition Methods in the Stator Bar of Hydrogenerator

水轮发电机定子线棒4种换位的分析与比较

It's demonstrated that thrust bearing load of Francis hydrogenerator with down-shelf supporting structure can be regarded as maximum vertical excitation force of hydropower house vibration.

同时论证了对于下机架承重的混流式水轮发电机组可采用其推力轴承负荷作为水电站厂房振动的最大垂直激振荷载。

Realization of Air Gap Monitoring System of Hydrogenerator Units

水轮发电机组气隙状态监测系统的实现

The Application of Forging and Welding Construction to Thrust Block of Vertical Hydrogenerator

锻焊结构在立式水轮发电机推力头上的应用

Development of a Device for Turn-to-Turn High-Voltage Test of the pole Coil of Hydrogenerator

水轮发电机磁极线圈高压匝间试验装置的研制

A CAT System of Dynamic Measuring of Hydrogenerator Air Gap

水轮发电机动态气隙测量的计算机辅助测试系统

It's a important join component of hydrogenerator main shaft fasten joint bolt.

水轮发电机主轴联轴螺栓是水轮发电机重要的联接部件.

The Application of New Technique of Stator Integrality, Cohering, Hot Pressing and Heat Expand Gap Setting to Hydrogenerator

水轮发电机定子整体化结构、铁芯热压粘结和热膨胀间隙新技术的应用

Guide bearing of vertical hydrogenerator carries the radial force from its rotatory parts.

立式水轮发电机的导轴承承受转动部件的径向力.

The paper depicts the magnetic energy calculation for no load of hydrogenerator de excitation energy capacity calculation with linear and non linear resistor.

本文分析了空载水轮发电机磁场能量计算和空载误强励下，用线性电阻或非线性电阻灭磁时灭磁能容的计算。

The safety running of hydrogenerator needs thrust bearing sharing thrust load.

水轮发电机组的正常运转要求各推力轴承轴瓦应均匀地承受推力负荷。