interlaminar

Besides, the effect of diffusion coefficient on interlaminar shear stength of composites is investigated.

此外, 还研究了扩散系数对芳纶纤维复合材料的层间剪切强度的影响.

Using this experimental system, interlaminar deformation and damage in AS4/ PEEK composite laminates are revealed and measured under uniaxial tensile loading.

在轴向拉伸载荷下，用该系统对AS4/PEEK层合板的层间变形与损伤的细观过程进行了连续、实时、定量测试。

Aiming at anti-slide performance and anti-seepage performance in pavement performance we measured the texture depth and water permeability coefficient. Finally, we researched on interlaminar shear strength between the micro surfacing and pavement using the determined gradation and the optimum emulsified asphalt content.

路用性能测试主要针对抗滑性能和防渗水性能进行了构造深度和渗水系数的测定。最后，采用确定的级配和最佳改性乳化沥青用量，研究微表处与原路面的层间剪切性能。

Ambitious attempts to improve interlaminar shear strength have been made by Mueller Prosen and by Keogh.

米勒·普罗森还有基奥都对提高层间切变强度作了大胆的尝试.

The results showed that the bridging effect of interlaminar short fibers can effectively reduce the stress concentration and crack-tip energy release rate, thus toughening significantly the short fibers.

结果表明：层间短纤维的桥联作用有效地降低了层间应力集中程度和裂尖能量释放率，增韧效果明显。

Interlaminar tensile rupture and fracture analysis for cf/ epoxy materials

碳/环氧复合材料层间拉伸断裂与断口分析

Indirect Methods: To measure the interface bond strength include the interlaminar shear strength test.

测量界面粘结强度的间接方法包括层间剪切强度试验.

Increasing the temperature of preheating, the mandrel-pressure roller and the hot air gun and choosing the moderate pressure of pressure roller come along with a rise in interlaminar shear strength ( ILSS) and a reduction in resin content.

结果表明：提高芯模压力辊温度、热风枪温度、预热器温度，选择适中的压力辊压力，在层间剪切强度提高的同时，树脂含量下降。

Bending and Torsion Testing of Thin Laminated Cylinder with Interlaminar Hybrid

层间混杂薄壁圆筒抗弯扭特性的实验研究

Analysis results show that asymmetry plies increase the hoop interlaminar shearing stresses by 0.

表明铺层的不对称性会显著导致环向层间剪应力增大,增幅在0.

New Research on Interlaminar Stresses in Piezoelectric Laminates

压电层合板层间应力新研究

The in-plane modulus of elasticity and interlaminar stress are used as the constraint function and the objective function respectively.

用面内弹性模量和层间应力分别作为设计空间的约束函数和目标函数。

The damage of plane with cutout is mostly caused by the interlaminar fracture around the hole.

开口的损伤也主要是由孔边的层间失效引发的,开口缝合补强的引入,可以改善孔边的层间力学性能.

Study on interlaminar tensile strength of carbon fiber/ epoxy composite

碳/环氧复合材料多向层间拉伸强度的研究

The analysis of interlaminar bearing stress in composite laminated beam is supplemented in this paper, on which the theory of "replacing design" is based. A simple calculation method applied to engineering design is suggested, too.

本文补充了复合材料层合梁等代设计理论的层间挤压应力分析内容，提出了便于工程设计应用的简便算法。

Simplified Analysis and Calculation of Interlaminar Bearing Stress in Composite Laminated Beam

复合材料层合梁层间挤压应力的简化分析计算

Test method for interlaminar tensile strength of glass fiber reinforced plastic laminates

GB/T4944-1996玻璃纤维增强塑料层合板层间拉伸强度试验方法

The dynamic interlaminar stresses of rectangular composite material laminated plates with simply supported edges subjected to free vibration are studied beginning from basic geometric and differential equations and connecting with generalized Hooke's law.

本文从基本的几何方程和运动方程出发，结合广义虎克定律，研究了四边简支矩形复合材料层合板在受到横向自由振动时的动态层间应力。

This paper aimed at acquiring the real interlaminar shear strength in tension test.

在拉伸负荷方式下，层间剪切强度的测定受弯曲力矩的影响。

This paper is to discuss the interlaminar stresses of adhesive lap joint by the energy method without considering the adhesive layer.

本文以能量法求解无胶层厚度的搭接接头的层间应力。