From the calculation of the plate pressure difference of the throttled surge chamber, analyze the numerical value of the influence of the superimposition on it.

It is necessary for this guidance method to provide the time-varying thrust for three directions through a throttleable engine and attitude maneuvers.

由于制导律要求同时提供3个方向的时变推力，所以需要通过变推力发动机和姿态机动来实现。

Analysis on Characteristic of Gradual Change Throttleable Cushion in Hydraulic Cylinders

液压缸内渐变节流式缓冲装置的特性分析

The wellhead throttle valve is made up of nozzle, plunger-shaped spool, throttle value, valve body and valve rod, etc.

该井口节流阀由喷嘴、柱塞形阀芯、节流轴、阀体、阀杆等组成。

The use of the active stick and throttle and a cutoff switch was introduced on the JSF demonstrator, the X-35.

主动驾驶杆和油门杆以及动力切断开关从X-35，也就是JSF的演示机开始就引入了。

Analysis on the Fracture of Throttle Device of Main Steam Pipe

主蒸汽管节流装置爆裂原因分析

It is concluded that the problem was caused by the poor coordination of opening and closing speeds of throttle steam valve ( TV) and governor valve ( GV).

分析认为阀门切换过程汽机转速波动大的原因是主汽门（TV）与高压调门（GV）的开启和关闭速率配合不好造成的。

With the increase of throttle resistance, the product purity increases;

在本实验条件下，随着反吹阻力的增大，产品气的纯度升高，但其升幅逐渐减小；

In order to reduce the loss of turbine throttle valve regulator and guarantee a high unit efficiency, the sliding pressure operation mode is widely used when unit load is changing.

为了减小汽轮机调节阀的节流损失并保证较高的机组运行效率，火电机组变负荷时采用滑压运行方式。

Improvement of inlet throttle velocity regulator in lathe hydraulics system

机床液压系统中进口节流调速回路的改进措施

Design of Throttle Velocity Regulator System Based on Virtual Instrument

节流调速控制台的虚拟仪器软件设计

The traditional method is to use the throttle regulator buck expansion, the exergy loss in the process of throttling is relatively large, makes a lot of energy being wasted.

传统的调压方法是采用节流阀膨胀降压，节流过程中火用损较大，使得大量的能量被白白浪费掉了。

The article analyses two throttle speed regulation hydraulic system and presents the control method to in line throttle speed regulation hydraulic system.

分析了两种节流调速液压系统，提出了进油路节流调速系统的控制策略。

8D large-sized centrifugal fan was conducted in three respects: outlet throttle regulation, flow-guide regulation and variable speed regulation. Noise characteristic curves under off-design conditions were obtained.

8D大型离心式风机分别进行了出口节流调节、导流器调节和变速调节3种方式下的噪声特性实验研究，得到了变工况下的噪声特性曲线。

The writer did some research on energy saving effect of pumps with variable speed motors and throttle regulation.

对输油泵采用变速与节流调节的节能效果进行了探讨与研究。

An ejector should be adopted in some low cooling-capacity refrigerating systems instead of a throttle valve to recover some high-pressure potential power and reduce the irreversible energy loss of throttle process for improving the energy efficiency ratio ( EER) of the CO_2 system.

为减小CO2跨临界循环系统节流部分的膨胀功损失，提高系统性能，可在小型制冷系统中采用喷射器代替节流阀，部分回收工质从高压到低压过程的膨胀功。

The determination of throttle coefficient of real gas in adiabatic throttle process is discussed in this paper.

讨论了实际气体绝热节流系数的计算，节流系数可用计算法和作图法来确定。

By discussing the detailed structure of increasing pressure element, heat transfer elements, throttle and the working process, the structure design of the refrigerating system is introduced based on low pressure air as power and working medium.

通过详细论述增加单元，换热单元和节流制冷单元的结构和工作过程，介绍了一种以低压空气作为动力和工作介质的制冷系统结构设计。

Such nonlinear characteristic as flow through a throttle and the thermodynamic process in a chamber make it difficult to design a controller for pneumatic servo system.

为提高控制系统的鲁棒性，增强干扰抑制能力，提出了适用于气压伺服系统的自抗扰控制器方案，并讨论了控制参数的整定。

Study on Flat Plate Throttle Cushion Process of High Speed Hydraulic Cylinder

高速液压缸平板节流缓冲过程的研究

The determination of throttle coefficient of high-pressure natural gas in adiabatic throttle process is discussed, and the average throttle coefficient can be calculated by the enthalpy-pressure chart and equal enthalpy equation.

讨论了高压天然气绝热节流过程中节流系数的确定。任意状态下的节流系数可利用计算式确定，平均节流系数可利用天然气的焓-压图和等焓计算式确定。