In this paper PMMA and pine are chosen as two typical solid materials. The method based on the principle of oxygen consumption is applied, the Calorimetry System is used, and the heat release rates of solid combustion with different fluxes radiant heat are measured.

Influence of ingredients on thermal oxidative stabilities of NR/ BR vulcanizates were studied by DSC.

本文用差示扫描量热计（DSC）研究了天然橡胶（NR）与顺丁橡胶（BR）并用硫化胶的耐热氧稳定性。

Specific heat capacities of 5 gasoline fractions were measured at temperatures from 243K to 299K by a differential scanning calorimeter ( DSC) with an average deviation less than ± 2%.

用差示扫描量热计（DSC）测定5个汽油馏分（沸点小于200℃）在243～299K范围内的比热容，测量误差在±2%以内。

Further study on the cooling correction formula in isothermal calorimetry

恒温式量热计冷却校正公式的进一步研究

By DSC, melting points and temperature decline crystalline behaviours of BOPP principal and auxiliary materials were measured. The compositions of auxiliary materials were analyzed qualitatively, and the application of the testing results in BOPP production was discussed.

用差热扫描量热计（DSC）分析仪测定了BOPP主料、辅料的熔点及降温结晶行为，定性分析了辅料的组成，探讨了测试结果在BOPP生产线上的应用。

The flammability of PE/ clay nano-composites has been studied by means of cone calorimeter and TG.

使用锥形量热计、热重分析仪对聚乙烯（PE）/粘土纳米复合材料的燃烧性能进行了研究。

The structure and performance of a silicon absorbed dose calorimeter are reported. The experimental results for flash X-ray radiation doses are presented.

报道了一台硅吸收剂量量热计的结构和特性，给出了用该量热计测量脉冲X射线辐射剂量的实验结果。

Calibration and Measurement of A New Type Self-Compensation Gamma Thermometer

新型自补偿γ量热计的刻度及测量

Study on the combustion performance of the timbers-CONE calorimeter

木材的燃烧性能研究&锥形量热计法

The heat release graphs of platelets cryopreserved with or without 5% DMSO were also measured by differential scanning calorimeter ( DSC).

同时利用差式扫描量热计（DSC）记录加和不加5%DMSO的血小板在降温过程中的放热峰。

This calorimeter has the advantage of simple structure and quick measurement.

该量热计轻便、简单、测量迅速而准确。

The influence of zirconium on the crystallization and phase transformation of amorphous Co-Si thin films was investigated by X-ray diffraction and differential scanning calorimeter.

利用X射线衍射分析技术结合差示扫描量热仪，研究了Zr在Co-Si合金非晶薄膜晶化和相变过程中的作用。

Rheometer, Polarized Light Microscopy, Differential Scanning Calorimetry are introduced to study the influence of copolymer on crystallization behavior of paraffins and asphaltenes aggregation condition of crude oil.

采用高级旋转流变仪、差示扫描量热仪（DSC）、偏光显微镜（PLM）等表征手段综合研究了梳型聚合物对模型油和原油中蜡晶的结晶行为、沥青质聚集状态的影响。

Crystallization behavior of PET changes with SSP. The isothermal crystallization of PET with SSP was investigated using differential scanning calorimetry ( DSC) and polarizing microscope ( with heating and freezing stage).

聚酯（PET）固相缩聚（SSP）中切片的结晶性能及其演变影响固相缩聚反应，采用差示扫描量热仪（DSC）和热台偏光显微镜研究了固相缩聚反应前后PET切片的等温结晶特性。

The effect of Sb, Bi and Fe on the melting points and microstructures of Cu-8P alloys were studied by means of DSC and SEM.

采用NETZSCHDSC404型差示扫描量热仪（DSC）、扫描电子显微镜（SEM）等手段研究了添加元素Sb，Bi和Fe对Cu8P共晶合金熔点和组织的影响。

Pore diameters were characterized by two different methods namely nitrogen desorption and small-angle X-ray scattering.

介孔的孔径用两种不同的方法进行表征，即N2吸附法和小角X射线散射；介孔中冰的熔点和熔化焓用低温差示扫描量热仪进行测定。

The diameter distribution, surface morphology, thermal properties and structure of the microcapsules were investigated by means of laser particle size analyzer, SEM, DSC and FT-IR, respectively.

利用激光粒径分布仪、扫描电镜、差示扫描量热仪（DSC）和傅立叶转换红外光谱仪分别研究了微胶囊的粒径分布、表面形态、热性能和壳结构。

The influence on its crystallization characteristics was also investigated by using PLM and DSC.

通过偏光显微镜（PLM）和差示扫描量热仪（DSC）对MB的成核效果进行了表征。

The latent heat and melting point of ammonium alum were determined by differential scanning calorimetry ( DSC) technique after repeated thermal cycles.

用差示扫描量热仪（DSC）测试了硫酸铝铵储能材料体系热循环后潜热、熔点的变化；

Two melting points of the crystal were obtained through differential scanning calorimetric ( DSC).

采用差示扫描量热仪（DSC）测定苦楝素晶体基本的理化常数&熔点。

And the glass transition temperature ( T_g) of TPI was analyzed by DSC.

利用差示扫描量热仪（DSC）测定TPI的玻璃化转变温度（Tg）；