meanwhile the tensile strength and flexural modulus of ipp could be increased by about 10% and 30%, respectively, and the haze value of ipp could be decreased by about 40%.

with content of silk fibroin of the sample increased, compression modulus and flexural modulus decreased gradually in the trend, when the content is less than 50%, the downward trend even more pronounced.

随着样品中丝素蛋白含量的增加，压缩模量及弯曲模量呈逐步下降趋势，当含量小于50%时，下降趋势更为显著。

when the content of the mmt was 5%, a heat deformation temperature of 154 ℃ and a flexural modulus of 3.335 gpa of the nanocomposite were obtained.

对其力学性能和热性能的分析发现，当有机化蒙脱土用量为5%（质量含量，下同）时，材料的热变形温度及弯曲模量分别达到154℃和3.335GPa。

with further increasing the epoxy resin content, the flexural modulus and tensile strength increase slowly and the impact strength varies slightly, while the elongation at break decreases rapidly.

继续增加环氧树脂的含量，共混物的拉伸强度和弯曲模量增加缓慢，冲击强度无明显变化，断裂伸长率进一步降低。

results showed that as the hardness of modified epdm increased the brittle-ductile transition moved to high rubber contents and the flexural modulus increased profoundly, however.

结果表明：随着EPDM硬度的增加，共混物不仅韧性提高，弯曲模量也大幅度上升。

this article indicates some defects in the old standard, analyses the developments in the new one, and also points out the method to improve the accuracy of flexural modulus.

对新老标准中有关弯曲模量的计算方法进行了比较分析和探讨，并对如何提高数值的精确度提出了几种方法，为更好地理解和实施新标准作了一些补充。

analysis and calculation for flexural modulus of symmetric multiply laminates study of the nonlinear forced flexural vibration of anisotropic composite symmetrically laminated plates

对称多层粘合板弯曲模量的分析计算各向异性复合材料对称角铺设层合板非线性弯曲强迫振动

the experimental results indicated that with the increasing of vf, the compressive strength decreased, and compressive, flexural modulus increased.

实验表明：随着V f的增大，材料压缩强度减小，压缩模量和弯曲模量增大；

the results show that impact strength and flexural modulus of glass fiber/ polypropylene increase greatly using the copolymer coupling.

结果表明：采用大分子偶联剂处理玻璃纤维可使玻纤毡/聚丙烯复合材料冲击强度和弯曲模量都得到很大程度的提高。

improves polypropylene's m.f.i, flexural modulus and impact strength.

改进聚丙烯的M.F.I、弯曲模量和冲击强度等指标。

prediction of flexural modulus and preparation of bagasse fiber-reinforced biodegradable composites

甘蔗渣纤维增强可降解复合材料的制备与弯曲模量的预测

three points bending test results show that there is an increase in flexural modulus with reinforcement contents.

三点弯曲试验表明，随着增强物的增加，弹性模量也增加。

the results show that the synthesized polymers possess both high impact strength and flexural modulus.

研究结果表明，开环歧化交联聚双环戊二烯是一种兼具较高模量、高冲击强度的结晶性高聚物。

meanwhile the tensile strength and flexural modulus of ipp were not significantly affected.

同时对聚丙烯拉伸强度和弯曲模量没有明显的影响。

experimental results show that the flexural modulus increases with the increases of the fibre content and length.

实验表明，随着纤维含有量和纤维长度的增加，材料弯曲模量呈递增趋势。

the nomographic chart of numerical forecasting storm surges in six harbours on guangxi coast was produced according to the calculation of 68 assumed storm surges by using a numerical forecasting model. the maximum storm surges elevation caused by various-track typhoons were forecasted.

根据台风暴潮数值预报模式，计算了68场假想台风所引起的台风暴潮，据此编制了广西沿海6个港口的台风暴潮数值预报诺模图，并预测各种路径下的台风所引起的最大增水值。

since the calculating formulas of heat pipe exchanger are complicated and the physical parameters of the working medium at different temperature need to be calculated, a nomographic method for the calculation of gas-gas heat pipe exchanger is presented.

针对热管换热器设计计算公式复杂，计算工作量大的问题，提出了采用线算图法进行气气热管换热器设计计算的方法。

by use of these nomographic charts, the dimension of the pipe system conforming with norms can be rapidly determined with a satisfactory precision accuracy.

可迅速求出符合规范的管网，并在保证精度前提下提高设计效率。

this paper suggests, in terms of the stress-strain curves, a nomographic method to measure the plastic stress by the strain-gage electrical logging method.

本文根据塑性变形下的应力-应变关系，提出用应变片电测法来求出塑性应力的专用材料图解法。

a study on nomographic method to determinate the basic dimensions for disk cam with oscillating follower

确定摆动从动件盘形凸轮机构基本尺寸的线图法研究

nomographic method for air infiltration calculation of highrise buildings

高层建筑空气渗透线算图的编制与使用