Thin的例句大全

Development of Surface Perturbation Target and Thin Silicon Foil Target Used to Research Rayleigh-Taylor Instability in Inertial Confinement Fusion Experiment

ICF分解实验中的平面调制靶和薄膜靶的研制

Some main contents and innovations in this paper are listed as follows: I. Copper nitride thin films were prepared by reactive radio-frequency magnetron sputtering of pure Cu target on glass substrates with various N2 flow rate.

主要内容和创新点如下：Ⅰ.以纯铜靶和氮气为原料，采用反应射频磁控溅射法在玻璃基底上成功制备了氮化铜纳米薄膜。

Al doped zinc-rich ZnO thin films are prepared at low temperature ( 200 ℃) using RF reactive co-sputtering technique with metal zinc and aluminum as target and soda lime glass as substrates.

以金属锌（Zn）和铝（Al）为靶材采用射频（RF）反应共溅射技术在低温（200℃）玻璃衬底上沉积了铝掺杂氧化锌（ZnO∶Al）薄膜。

By means of metallurgical analysis methods, macroscopical and microscopical characteristics for thin Si-Mn armour steel target subjected to penetration of real shaped charge jet have been investigated.

借助于冶金分析方法研究了硅锰装甲钢薄靶破甲弹坑的宏观和微观特征。

Development and trend of transparent conductive thin films and target whose general property is perfect by magnetron-sputtering are summarized.

阐述用磁控溅射技术制备综合性能优良的ZAO透明导电薄膜及其靶材的发展现状和趋势。

Our results reveal that high pyroelectric property of BST thin film could be achievable using inverted cylindrical RF sputtering with high target self-bias voltage.

研究结果表明，利用倒筒式射频溅射方法，适当提高自偏压，可以制备出热释电性能优良的BST薄膜。

Deposited at high target self-bias voltage, the BST thin films are highly ( 100)-orientation, and have smooth surface, excellent crystallinity and good withstand voltage properties.

在较高自偏压下制备的BST薄膜具有高度的（100）择优取向，且结晶性好，表面平整，耐压能力强。

Conclusion: In spiral CT simulator scan, using overlapping reconstruction with thin slice is advisable in determining gross target volume of tumor.

结论：在螺旋CT模拟扫描中，采用薄层的重叠重建在肿瘤靶区体积的制定中是切实可行的。

Again, if you look at some maps, you see relatively thin sanctions of northern Iraq and Syria under ISIS control.

如果你看过这些地图的话你就可以看到有相对来说比较少的伊拉克和叙利亚北部领土被ISIS控制。

The research on the water leaching rate of bag tea of the root of kudzu vine and thin-layer chromatography is discussed.

介绍了葛根解酒袋泡茶的水浸出率及薄层层析实验研究。

The stratospheric aerostat permanently stayed in the complex space environment with thin air and strong effect of ultraviolet radiation and ozone. Excellent properties like lightweight, high strength, tear resistance, high sealing and anti-aging are the key technical requirements of envelope material.

平流层浮空器长期驻留于空气稀薄、紫外线辐射和臭氧作用强的复杂空间环境中，轻质、高强度、抗撕裂、高阻隔和抗老化是其蒙皮材料的关键技术性能要求。

In China, the sectional thickness of primary component is restricted by "The Technical Criterion on Cold-formed Thin-wall Steel Structure".

我国现行《冷弯薄壁型钢结构技术规范》（GB50018-2002）对主要承重构件的截面厚度进行了限制，主要适用于仓库，厂房等公用建筑。

In the study, conventional methods and technical of reservoir description were used mostly to do thin layer division and contrast, sedimentary microfacies and sand body distribution and characteristics of effective sand delineation and distribution and so on.

在研究手段及方法上，主要采用常规油气藏描述技术及方法对气藏进行小层对比划分、沉积微相及砂体展布、有效砂的划分及展布特征等一系列研究。

In this paper, the technical detail is discussed through the research of the thin walled column crash simulation.

本文通过薄壁直梁件的碰撞仿真研究，对碰撞仿真的技术细节进行了深入的研究。

Therefore, in the ultra-thin sheet forming process, the size effect should be considered in the selection of the technical parameters in order to satisfy the design.

因此，在超薄板料的塑性成形过程中，工艺参数的选取需要考虑其尺度效应才能达到设计要求。

Pressing thin wall components requires Constant velocity while the operation process.

薄壁零件在冲制过程中要求匀速拉延成形。

Analysis and Application of Automatic Welding on the Thin Section Workpiece

薄壁件自动焊接的分析与应用

Development of Test System for Space Position of the Thin Liquid Controlled by Computer

微机控制细液流空间位置测试系统

The test pressure coefficient and safety factor are searched for thin-wall vessels with minimum virgin reliability of burst strength in different working conditions.

从控制薄壁内压容器在不同工况下最小初始可靠度的角度，对其试验压力系数与安全系数进行了探索。

Application of Wind Pressure Draining Dust Technology to Construction Drainage Drilling in Soft, Thin Seam

压风排粉技术在松软、薄煤层施工抽放钻孔中的应用