internal failure的例句大全

Internal failure is the most expensive quality cost component.

内部的失败是最昂贵的质量成本的组成部分.

Internal Failure Factors and Related Countermeasures of College Students Starting an Enterprise

大学生创业失败之内因与相关对策

The failure of the contract first brings about the failure of the target function in the enterprise. Furthermore, it leads the enterprise into the internal failure of its adjust function.

契约失效首先是国有企业的目标功能失效，进而使企业的内部调控功能失效。

FATAL: internal failure, system halted.

严重出错: 内部错误, 系统中止.

Using the content of SO_2 and H_2S diagnosing the internal failure of SF_6 electrical equipment

应用SO2、H2S含量诊断SF6电气设备内部故障初探

Internal failure initializing the general notification object. Some features of the application will be disabled

内部失败初始化常规通知对象。应用程序的某些功能将不能使用

Internal failure of any module or component on the bus

母线的任何模组或组件失效

MSB4014: The build stopped unexpectedly because of an internal failure

MSB4014：由于内部错误，意外终止构建

Once the internal failure of any structural element, may lead to unstable operation of equipment, or even the possibility of paralysis of the entire device. This will not only cause huge economic losses, severe personal safety will be endangered.

一旦其内部任何组成部分出现故障，都有可能导致整个系统运行不稳定，甚至系统瘫痪的可能性，这不仅会造成巨大的经济损失，严重时还会危及到人身安全。

The internal failures of Alternating Current motor are divided into mechanical failure and electric failure.

交流电动机的内部故障可分为机械故障和电气故障.

Not only the non-linear characteristics is considered but also the impact of residual magnetism Finally, dynamic test is set up under the situations of internal failure, external fault, closing with no-load.

这样既可以模拟非线性同时又考虑了剩磁的影响。最后，针对内部故障、外部故障、空载合闸等情况进行了动模实验。

The method of judging transformer internal failure by using gas-forming rate is introduced. The problems which should be paid to attention in inspecting gas-forming rate are pointed.

介绍了利用产气速率判断变压器内部故障的方法，指出了考察产气速率应注意的问题。

Judging Transformer Internal Failure by Using Gas-Forming Rate

利用产气速率判断变压器内部故障

Analysis on the failure cause of the internal fixation in the forearm fracture

前臂骨折内固定失败原因分析

The ultimate failure mode of the experimental model is overall bending failure. The specific process is the buckling of the bottom chords, redistribution of internal force and the large deflection.

试验模型结构最终的破坏模式为整体弯曲破坏，具体过程表现为下弦杆屈服，内力重分布，挠度过大。

of them, 65 cases underwent conventional dilation, in them 59 ( 90.8%) were cured and 6 had failure, then turning to internal urethrotomy;

行单纯尿道扩张术65例，治愈59例（90.8%），失败6例改尿道内切开术；

The simulation results indicate that the improved algorithm can greatly improve efficiency and accuracy of internal combustion engine failure diagnosis system.

仿真结果表明，这种改进算法极大提高了内燃机故障诊断系统的效率和准确性。

The Internal Relations of Oxymoron and Ways for Comprehension A study of the Relationship between Ring Failure and Internal Quality of Rings

Oxymoron的内在联系及理解钢领失效与内在质量关系的研究

The residual internal contamination from machining and assembling procedures of hydraulic parts is the main cause of pre-mature failure and down-time of hydraulic systems.

液压元件在加工和装配过程中残留于内部的污物是造成液压系统早期失效和故障的主要原因。

However, this ruling model led to the failure of Soviet Union communism, because of its internal structural deficiency.

苏共执政模式曾使苏联取得了诸多成就，但这种执政模式内在的结构缺陷，最终导致了苏共的彻底失败。