ohmmeter的例句大全

If a test button is not supplied, the integrity of the circuit may be checked with an ohmmeter.

如果没有配置测试按钮，则可以采用欧姆表测试线路的完好性。

The best measuring range of ohmmeter considering the influence of zeroing

计及调零影响，算欧姆表表尺最佳段范围

USING AN OHMMETER MEASURE THE RIGHT VTSS DISARM SENSE CKT TO GROUN closed-circuit television common antenna system

用欧姆计接地测量右VTSS防盗系统关闭感知电路。闭路电视共用天线系统

High resistance measurements using the constant-current method may be made using either an electrometer voltmeter and current source or just an electrometer ohmmeter.

采用恒流法，可以使用静电计电压表和电流源或者只使用静电计欧姆计来测量高电阻。

According to a resistance center value to repair ohmmeter of avometer.

利用万用表的电阻中心值，修理万用表的欧姆档。

using an ohmmeter, check the resistance between the commutator and the armature core.

使用欧姆计，检查在换向器和电枢之间的电阻。

this small resistance is normally measured with a dmm or a micro- ohmmeter.

这个小的电阻值通常用数字多用表或者微欧姆计来测量。

measurement of earthling resistance and verification of earthling ohmmeter

接地电阻的测量和接地电阻表的检定

v meg - ohmmeter used to measure the insulation resistance

伏兆欧表测绝缘电阻用

discussion about ohmmeter inner resistance and multiplying power

关于欧姆表内阻和倍率的探讨

The most basic instruments include an ammeter, voltmeter, and ohmmeter . 2.

最基本的仪器包括安培表, 电压表和电阻表.

Using an ohmmeter check the resistance between the commutator and the armature core.

使用欧姆计,检查在换向器和电枢之间的电阻.

Using an ohmmeter check the resistance between the segments of the commutator.

使用欧姆计,检查在换向器之间电阻.

USING AN OHMMETER MEASURE THE GROUND CIRCUIT AT KEY-IN IGN SWITCH CONN.

利用欧姆计测试在钥匙点火开关接头的接地电路.

The ohmmeter uses an internal current source and electrometer voltmeter to make the measurement.

欧姆计使用内部的电流源和静电计电压表来进行测量.

When using the electrometer ohmmeter, measurement accuracy can be affected by a variety of factors.

使用静电计欧姆计时, 测量准确度会受到各种因素的影响.

Using an ohmmeter, check the resistance between the brush lead and the starter yoke.

使用欧姆计, 检查电刷和起动机外壳之间的电阻.

Attach test leads to pins 1 and 2 and note ohmmeter reading.

把测试探针连接到插头1和2,并记下欧姆表读数.

Using an ohmmeter, check the resistance between terminal 50 and the switch body.

使用欧姆计, 检查在电磁开关50和外壳之间的电阻.

WITH THE DRB IN OHMMETER MODE, MEASURE THE GROUND CIRCUIT.

用DRB的欧姆计模式, 测量接地电路.