scuffing的例句大全

1、

Smaller particle of the talc leads to higher smoothness, gloss, air permeability, ink set-off and scuffing properties, but reduces surface strength and printing contrast.

粒度较小的滑石粉导致更佳的平滑度、光泽度、透气度、油墨干燥性以及耐摩擦性，但也导致更低的表面强度和印刷对比度。
来源：互联网摘选
2、

Study of monitoring on line about the gear scuffing test

齿轮胶合试验在线监测方法研究
来源：互联网摘选
3、

Study on calculating and test method for gear scuffing

齿轮胶合的计算和试验研究
来源：互联网摘选
4、

Analysis and Calculation of Fuzzy Reliability on Scuffing Resistance of Gear Drive

齿轮传动抗胶合模糊可靠性分析与计算
来源：互联网摘选
5、

A study of the cold scuffing of low speed and high load gears

低速重载齿轮冷胶合机理及试验研究
来源：互联网摘选
6、

Mechanism analysis and betterment measure on scuffing of hydraulic pressure equipment

液压升降装置拉缸机理分析和改进措施
来源：互联网摘选
7、

Research of Test on Gear Scuffing and Monitoring Technique

齿轮胶合的试验研究及其监测技术
来源：互联网摘选
8、

The Experimental Research on the Scuffing Load Capacity of Worm Gear Oil

蜗轮蜗杆油胶合承载能力试验研究
来源：互联网摘选
9、

Standard test method for scuffing load capacity of gears

GB/T13672-1992齿轮胶合承载能力试验方法
来源：互联网摘选
10、

Effect of Lubricating Oil Temperature on Gear's Scuffing Resistance

润滑油温度对齿轮胶合承载能力的影响
来源：互联网摘选
11、

Research on Cylinder Scuffing Simulation Experiment of Diesel Engine

柴油机拉缸故障模拟试验研究
来源：互联网摘选
12、

Reliability Analysis and Calculation of Scuffing Load Capacity for Gear Transmission by Flash Temperature Method

基于闪温法的传动齿轮抗胶合可靠度分析与计算
来源：互联网摘选
13、

Experimental Simulation and Theoretical Analysis on Scuffing Failure of Piston Ring Cylinder Liner

内燃机活塞环-缸套擦伤的理论分析与试验模拟
来源：互联网摘选
14、

Experimental Study on the Reliability of Extrapolation of Critical Temperature in Gear Scuffing

反推齿轮胶合临界温度可靠性的试验研究
来源：互联网摘选
15、

Study on the scuffing strength of micro-segment helical gear

斜齿微线段齿轮胶合承载能力的研究
来源：互联网摘选
16、

New Variation of Critical Temperature in Gear Scuffing

齿轮胶合临界温度的变化新规律
来源：互联网摘选
17、

The experimental results showed there exists influence of the oil temperature on the scuffing resistant.

试验结果表明：供油温度对摩擦副的抗咬死性能有较大的影响。
来源：互联网摘选
18、

A Study of Contact Fatigue Resistance and Scuffing Behavior of Retained Austenite

残余奥氏体的抗接触疲劳及擦伤行为的研究
来源：互联网摘选
19、

A Twice& Optimization Method for Increasing the Strength and Scuffing Load Capacity of Gears

齿轮弯曲强度与胶合强度的二次优化法
来源：互联网摘选
20、

The research method adopted in the paper are fo some significance to the study of gear scuffing mechanism and the study to increase the gear scuffing load carry capacity.

本文的研究方法对齿轮胶合机理和提高齿轮胶合承载能力的研究都是有意义的。
来源：互联网摘选

scuffing的例句大全

赞达亚与荷兰弟 Tom Holland 订婚啦！

印尼成为金砖国家正式成员

霸总微短剧泛滥：广电总局出手整治“霸总”微短剧

七年级上册英语阅读理解专项训练21（含答案解析）

加拿大选手巴黎奥运会游完塞纳河后狂吐10次！

伊万卡迈阿密观看泰勒·斯威夫特演唱会，特朗普曾公开“讨厌”霉霉！