separation temperature的例句大全

Effects of PPVA activity layer esterification degree, separation temperature and feed EtOH concentration on the PPVA/ PAN composite membrane separation properties were all investigated.

考察了PPVA活性分离层的酯化度、分离温度、进料浓度等因素对复合膜的分离性能的影响。

It explores the influence of different extraction conditions ( extraction pressure, extraction temperature, extraction time, separation pressure and separation temperature) and optimizes the technical parameters of the oil extraction from above seeds.

探讨了不同萃取条件（萃取压力、萃取温度、萃取时间、分离压力和分离温度）对提取率的影响，探讨提取上述种籽油脂的最佳工艺参数。

The research results are as follows: 1. The main parameters that influence the Supercritical CO2 extraction are extraction pressure, extraction temperature, extraction time, separation pressure and separation temperature.

取得以下研究结果：1.影响超临界萃取工艺的主要参数有萃取压力、萃取温度、萃取时间、分离压力及分离温度。

After temperature jump, the phase separation of PS/ PVME system with critical composition is spinodal decomposition.

临界组成的PS／PVME体系在温度跃升后，相分离动力学遵循旋节分相（spinodal decomposition）机理。

Study on the separation property of the temperature sensitive gel

温敏性水凝胶对蛋白质和酶浓缩分离性能

Separation of Minerals by Means of Heavy Liquid with Temperature Changing and Its Application in Rb-Sr Geochronology

重液变温分离单矿物在铷锶年代学中的应用

Land surface temperature retrieval is a hot and difficult problem in the research of thermal infrared remote sensing, in which atmospheric correction, temperature and emissivity separation must be considered.

地表温度反演是热红外遥感研究的热点和难点之一，大气校正、温度与比辐射率的分离是必须考虑的两个重要方面。

Low temperature separation, uses the high energy from the well stream to throttle and reduce pressure, then remove the condensate.

低温分离，是利用地层本身能量节流降压制冷，用低温分离方法脱除天然气中凝液的处理工艺。

The former has a double-layer bearing structure with small supports that make such separation between thrust bearing shoe and bearing pillow that asymmetrical temperature distribution on the thrust bearing shoe has minimum impact on the bearing pillow with a lower thermal deformation.

巴氏合金瓦推力承轴采取小支柱双层瓦的结构形式，由于小支柱将推力瓦和托瓦分开了，使推力瓦的不均匀温度分布对托瓦影响极小，不会引起较大的热变形。

The pyrolysis temperature extension and its time separation are fairly close; they can be simulated under one same pyrolysis model and come out with satisfactory result.

热解温度范围和热解时间间隔相近，可以用同一个热解模型进行模拟，得到了令人满意的结果。

In influence of the treatment temperature, residual gas pressure and vacuum treatment time on separation effects were completely investigated.

主要研究了蒸发温度、真空度和蒸发时间等因素对阳极泥蒸发率的影响，并对冷凝物的形态控制及贵铅的后续处理进行了探讨。

The increase of temperature could improve the separation factor and a maximum separation factor of 5 40 was obtained at 60 ℃.

提高温度可以提高分离因子，在60℃获得最大分离因子540。

The heavy liquid separation with temperature changing has been applied to separate minerals of muscovite, biotite, sanidine and quartz to obtain several fractions with respect to specific gravity difference. All of them were dated by conventional Rb-Sr isochron method.

报道了应用重液变温分离法分离白云母、黑云母、透长石和石英等单矿物，进行铷锶等时线年龄测定的研究结果。

A thermal temperature and emissivity separation algorithm based on Wien approximation and Alpha derived emissivity method ( ADE) are proposed.

提出了一种基于维恩近似修正和阿尔法获得法（ADE）的温度和发射牢的反演方法。

This article first studied the influence of operating pressure, time, temperature and recovery on the separation performance of NF membrane.

首先研究了操作压力、时间、进水水温及回收率对纳滤膜通量变化的影响。

Dynamic mechanical results shows that the important influence on, phase separation in PVAc/ PMA-IPNs, is from the temperature of synthesis and sol-gel transition during the process of IPNs' preparation.

动态力学的实验结果表明，丙烯酸甲酯的聚合温度和聚合过程中的溶胶-凝胶转变对PVAc/PMA-IPN体系的相容性有很大影响。

The separation factor decreases as exponential function accompanying with increasing temperature.

分离因子随着温度升高以指数函数下降。

The total gas& solid separation efficiency under ambient temperature was higher than 99%, when the gas linear velocity was in the range of 6-20 m/ s.

当提升管内气体线速在6～20m／s时，冷态下的气固分离效率可达99%以上。

The increase of reheating temperature and MgO content are beneficial for the separation of phlogopite crystals, and cause an higher aspect ratio of the phlogopite phase, which improves the machinability of the glass-ceramics.

热处理温度和MgO含量的增加有利于云母晶体的析出及云母晶体径厚比的增加，改善微晶玻璃的可切削性。

Colloidal SiO2 concentration, pH, temperature, electrolyte, precipitant and agitation condition are the main factors affecting separation performance.

SiO2溶胶的浓度、pH、温度、电解质、聚沉剂和搅拌强度是影响矿浆固液分离性能的主要因素。