system load的例句大全

Electric vehicle ( EV ) chargers are highly linear power system load.

电动汽车 充电机是非线性的设备,工作时产生的谐波电流很高.

The pattern also avoids additional system load by avoiding retries from users.

这种模式还通过减少用户的重试次数降低了系统的负担.

It is a formulaic calculation based on various components of system load.

它根据系统负载的各个组成使用公式进行计算。

you should enforce a few limits in mysqld to ensure that the system load doesn't cause resource starvations.

您可以在mysqld中强制一些限制来确保系统负载不会导致资源耗尽的情况出现。

Multi-centralized control: The controller can be a focus of many central control console, according to system load and run-time units decide the host job status.

多机集中控制：用一台集中控制器可以对多台主机进行集中控制，根据系统负荷及个单元运行时间决定主机工作状态。

Realization of No.7 Signalling System Load Sharing to in S12

No.7信令系统负荷分担在S12中的实现

Presently, the complete loading calculation mode is widely used as the design method of the metro station, but the vertical load from the temporary road surface system isn't taken into account.

目前，我国地铁车站设计中普遍采用的一次加载的计算模式，也没有考虑盖挖施工临时路面体系传递的竖向荷载。

Based on the advanced technology and instruments of visible monitoring system of section temperature field in furnace, energy saving& environmental protection test vehicle and 3-dimension furnace computational simulation, test and study are carried out on stability of peak-load regulation and optimization of operation of large unit.

利用炉膛断面温度场可视化监测系统、节能环保车、炉内三维数值模拟等先进的技术和设备对大机组调峰稳定性和运行方式优化进行试验和理论研究。

The system is used to test the motor including resistance test, temperature rise test, locked-rotor test, no-load test, load test and M-S curve test.

用于完成电动机的各种型式试验，包括电阻试验、温升试验、堵转试验、空载试验、负载试验和M&S试验。

According to nonlinear finite element analysis, the ultimate load-carrying capacity of tensegrity system is discussed based on the buckling of struts.

本文根据非线性有限元理论研究讨论基于压杆失稳的张拉整体结构极限承载能力。

The system can calculate conductor temperature and rating by using the monitored cable surface temperature, real-time load and the structure parameters of tunnel cables.

该系统通过远程监测电缆表面温度、负荷电流，结合电缆的结构参数以及隧道敷设环境，计算电缆实时导体温度和载流量。

The error of test-load on tractor hydraulic lift system and its compensation

液压悬挂试验的加载误差及其补偿

The practical application shows fine constant rate load ability of the system, which is of great value.

使用情况表明：该系统能够很好地实现恒速率加载，具有很大的实用价值。

Calculation of Heat Load and Drawing of Temperature Curve of the Heating System

供暖系统热负荷计算及供回水温度曲线的产生

Test results show that a relative uniform temperature distribution was obtained by this method to meet the thermal stress testing requirements, through making reasonable heating system, it can exert temperature load by classification and each grade of temperature ranges 9 ℃ to 11 ℃.

结果表明，该方法可为试件提供均匀稳定的温度场，满足温度应力试验要求，通过制定合理的升温制度，可实现分级施加温度荷载的目的，每级升温幅度为9℃~11℃。

Through the load test and tolerance test to network interface, we can inspect the robust performance of interface, it assures the system of dealing with the abnormal input correctly and improves the system's security and credibility.

通过网络接口的负载测试和容错性测试，可以对接口的健壮性进行检验，从而确保各种异常输入的正确处理，提高系统的安全性以及可靠性。

Based on the aging loss calculation, the limited value of temperature rise for F class insulation transformer on rated operating condition is derived. This value is satisfied with the desire of standard load system of duty class ⅴ and ⅵ.

通过寿命损耗计算，得出了F级绝缘变压器在Ⅴ级和Ⅵ级负载标准工作制条件下额定运行的温升限值。

This paper introduced a heavy load and super-length journey, high stability required lift telescopic cylinder and the principle of its pneumatic ( gas drive) control system.

本文给出了负载较大、行程超长、稳定性要求高的举升式伸缩气缸及其气动控制系统的原理及部分关键部位的优化设计方案。

Both SY/ T 5044-2003 and API SPEC 11E stipulate no load test and step stress test of the speed reducer and make sure the necessity of analysis on speed reducer system.

在SY/T5044-2003和API SPEC11E中都规定了减速器和抽油机整机的空载试验和分级加载试验，并明确了对减速器进行系统分析的必要性。

Based on comprehensive technical measurement and management measurement, the upstanding result are ultimately achieved by adopting load management system including load control, remote reading, data analysis and power check.

在综合技术措施和管理措施的基础上，采用负荷控制、远方抄表、数据分析和用电检查一体化负荷管理系统，最终取得了良好的效益。