Byte的例句大全

The sample code uses a utility class EtagComputeUtils to generate a byte array representation of an object and to handle the MD5 digest logic.

下面的例子使用了一个工具类EtagComputeUtils来产生对象所对应的字节数组，并处理MD5摘要逻辑。

If the EVPD parameter bit ( for enable vital product data) is zero and the Page Code parameter byte is zero, then the target will return the standard inquiry data.

如果EVPD参数位（用于启用关键产品数据）为0并且Page Code参数字节为0，那么目标将返回标准inquiry数据。

The Process for Tandem Connection Monitor Byte N1

串接链路监视字节N1的处理

Analyses and simulations to determine the maximum BER that can be detected ( i.e., the saturation BER) and the minimum detection efficiency are given. Conclusions are drawn as follows: one BIP byte per tandem connection monitoring field is adequate for performance monitoring;

在此基础上，模拟并分析了不同EDC所能检测的最大误码率（饱和误码率）和最低检测效率，得出为每个串接监视域分配一个BIP字节可以满足性能监视的需求的结论。

all scsi commands should also contain a control byte.

并且所有SCSI命令都要包含一个控制字节。

the quantity of setting and control byte is suggested to be as small as possible to simplify the setting calculation of microprocessor-based protection equipment, and corresponding measures are proposed.

为简化整定计算，提出尽量减少微机型继电保护装置的定值数量及运行方式控制字，并给出了相应的有效措施。

the pwm generator has a control byte ( 8 bits) that is used to provides a continuous, variable duty cycle output with user control of the cycle time and the pulse width.

在使用PWM高速脉冲输出时，通过控制字节的设置来改变脉冲宽度和脉冲周期，实现控制任务。

the receive index defines the information start and end based on using the receive information to control byte bit.

接收指令使用接收信息控制字节中的位来定义信息启始和结束。

the initialization consists of key a, key b, control byte and card no.

卡片初始化由发卡机完成，主要包括设置射频卡密码、控制字及初始化卡号等。

a one-byte status register - 8 status flags; read-only

一个字节的状态寄存器8个状态标志只读

converts an integer value from network byte order to host byte order.

将整数值由网络字节顺序转换为主机字节顺序。

converts a number from network byte order to host byte order.

将数字由网络字节顺序转换为主机字节顺序。

converts a short value from network byte order to host byte order.

将短值由网络字节顺序转换为主机字节顺序。

dclk use of the serial data output synchronous serial clock output then only a simple word or byte data buffer can be sent to the latch.

DCLK使用串行数据输出同步串行时钟输出，那么只有一个简单的字或字节的数据缓冲器可以送往门闩。

a line transmits the half byte serial data, while a serial-parallel converter reconverts the half byte serial data into a half byte;

以及串行-并行转换器，用于对所述半字节串行数据进行转换，以恢复所述半字节；

the part of a two-part memory address that remains constant and provides a reference point from which the location of a byte of data can be calculated.

保持恒定的两部分内存地址的一部分并提供一个基准点，从这里可以计算一个字节数据的位置。

stored with a byte integer part of the back of each byte stored two decimals.

通信中的数据解压缩。用一个字节存放整数部分，后面的每个字节存放两位小数。

the frame header is 8 bytes long, as follows (all values are 16-bit integers in network byte order, high byte first)

帧头有8字节长，如下（均由16位整数组成，网络字节顺序，高位在前）

opcode is a single-byte instruction, and local represents a local variable with an index greater than byte. maxvalue.

opcode是单字节指令，并且local表示索引大于Byte.MaxValue的局部变量。

acall is a two-byte instruction, and is limited to a 2k address block.

ACALL是两个位元组的指令，并仅限于2K的地址块。