Nanocomposites的例句大全

Structure and Properties of Non-Polar Polymer/ OMMT Nanocomposites

非极性聚合物/有机蒙脱土纳米复合材料的结构与性能研究

Tensile Characteristics of Low Filler Loaded SiO_2/ PP Nanocomposites

低填充SiO2/聚丙烯纳米复合材料的拉伸特性

Compared with neat PA6, the tensile modulus, the yield strength and the hardness of the nanocomposites were improved by about 100% 75%, and 25%, respectively, with incorporation of only 1 wt% CoAl-LDH.

当仅加入1wt%LDH时，尼龙6纳米复合材料的弹性模量、屈服强度和硬度比纯尼龙6分别提高了100%、75%和25%。

The experimental results showed that the obtained PET/ MMT nanocomposites exhibited fairly good overall properties when the MMT addition was 2.5% by mass fraction and the polycondensation terminal temperature was 250 ℃.

结果表明：MMT的添加质量分数为2.5%，缩聚反应终温250℃时，PET/MMT纳米复合材料具有较好的综合性能。

In a given crystallization temperature, the crystallization rate constant k of the PBS/ LDH nanocomposites is higher than PBS.

在给定结晶温度，PBS/LDH纳米复合材料的结晶速率常数k高于PBS。

These results show that new type of PMMA/ Nd ( OH)_3/ MMT nanocomposite with well thermodynamic stability through reverse micelle template was prepared organic-inorganic nanocomposites.

研究结果表明，利用乳液法制备出热稳定性良好的新型PMMA/Nd（OH）3/MMT三相纳米复合材料。

Due to increased phonon scattering, the Si nanowire nanocomposites with modification are expected to achieve lower thermal conductivity and larger thermoelectric conversion efficiency.

由于声子散射增强，经过修饰的si纳米线复合结构的热导率可以进一步降低，从而获得更大的热电转换效率。

Preparation and properties of rectorite/ thermoplastic polyurethane rubber nanocomposites

累托石/热塑性聚氨酯弹性体纳米复合材料的制备与性能

These sorts of advances could help developing nations, particularly those rich in renewable plant-derived raw materials, generate nanomaterials and nanocomposites more safely.

这类进展可能有助于发展中国家特别是那些可再生植物原材料丰富的国家更安全地制造纳米材料和纳米复合材料。

The results of DSC and TGA test showed the crystallizability and the thermal stability of nanocomposites were slightly decreased in the presence of LDH.

DSC和TGA测试结果显示：由于水滑石的存在，对纳米复合材料的结晶性能和热稳定性略有影响。

Structural aspects and thermal degradation of two kinds of clays& PVC Nanocomposites

两种粘土与PVC复合材料的热性能及微结构分析

Co3O4/ GO composites prepared by this method had good catalysis activity, which could largely low decomposition temperature of the AP and significantly increase heat release.CoFe2O4/GO nanocomposites were prepared by alcohol thermal method.

通过该方法制备的Co3O4/GO复合物具有良好的催化活性，能够较低AP的分解温度，并且大幅度提高AP的热分解放热量。

The thermal oxidative degradation of the polymer alloy and the nanocomposites was studied by thermogravimetric analysis ( TG).

用热重分析法（TGA）研究了聚合物合金和纳米复合材料的热氧化降解行为。

Progress of Polymer/ Montmorillonite Nanocomposites in Thermal Stability and Flame Retardation by Synergistic Action

聚合物基蒙脱土纳米复合材料的热稳定性能及协同阻燃研究

The results showed that TBC had some flame retardation on EPDM/ PP. Progress of Polymer/ Montmorillonite Nanocomposites in Thermal Stability and Flame Retardation by Synergistic Action

结果表明，使用TBC，EPDM/PP的阻燃效果较好，TBC主要发挥气相阻燃作用。聚合物基蒙脱土纳米复合材料的热稳定性能及协同阻燃研究

Effect of the clay surface grafting, interlayer ammonium and nanocomposites structure on the photo-oxidation, thermal degradation and thermal-oxidative degradation of PE nanocomposites has been investigated.

研究了硅烷接枝改性、铵盐插层以及黏土的分散等因素对材料的紫外光氧化、热降解和热氧降解性能的研究。

Polymethylmethacrylate ( PMMA)/ silica nanocomposites were prepared by conventional radical polymerization of methlymethacrylate ( MMA) in the presence of silica crosslinking agent ( SiO_2-HPA).

用SiO2交联剂（SiO2HPA）交联甲基丙烯酸甲酯（MMA）自由基聚合制备PMMA SiO2纳米复合材料。

Machinable 3Y-TZP/ BN ceramic nanocomposites with BN dispersoids ranging from 10 to 30% ( volume fraction, the same below) were prepared via in-situ reaction and subsequently hot-pressing.

利用化学包覆和热压烧结制备出3Y-TZP/BN纳米复相陶瓷，BN体积分数分别为10%~30%。

Studies on Soluble Polyimide/ Silica Nanocomposites via Sol-gel Process ── I. Studies on Sol-gel Transition and Reaction Mechanisms

溶胶-凝胶法制备可溶性聚酰亚胺/二氧化硅纳米复合材料的研究&Ⅰ.溶胶一凝胶转变过程和反应机理的研究

Study on mechanical property of exfoliated silicone rubber/ clay Nanocomposites

剥离型硅橡胶/黏土纳米复合材料研究