Salt的例句大全

The fusion time, fusion temperature, and equilibrium torque of rare earth stabilizer system were 2.5 min, 177 ℃, and 19.0 N · m, respectively, which were less than those of lead salt system, 4.3 min, 184 ℃ and 19.5 N · m.

稀土稳定剂体系的塑化时间、塑化温度和平衡扭矩分别为2.5min、177℃、19.0N·m，分别小于同配方铅盐体系的4.3min、184℃、19.5N·m。

The novel high temperature fluid loss additive named KCS-53 with functions of anti-caving and salt resistance is produced from humic acid by synthesis.

以腐植酸为主要原料。通过缩合、接枝共聚、金属离子螯合和磺化等系列反应制得了高温抗盐防塌降滤失剂K CS-53。

Conclusions as follows: ( 1) the effect of germinating time and rate emergence are different in soil with different salt content, and limited seriously in heavy saline soil.

得出以下结论：（1）土壤含盐不同对油葵种子萌发时间和出苗率影响不同。土壤含盐超过0.5%以上，出苗时间严重受抑。

The forming performance of aluminum hot extrusion without discard technology was studied under varied extrusion ratio, temperature and ratio of aluminum/ salt.

采用不同挤压比、不同加热温度和不同铝/盐比的实验条件，研究了铝材无压余热挤压工艺的成形性能。

A systemic evaluation is conducted on its temperature tolerance, salt resistance, shearing resistance, oil displacement efficiency and visible viscosity, etc.

对疏水缔合型聚合物的耐温性、抗盐性、抗剪切性、驱油效率及表观粘度等进行了系统评价。

It also has higher temperature tolerance, better salt and calcium resistance, good thermal stability and better inhibition.

具有较强的耐温和抗盐、抗钙能力，热稳定性好，具有较强的抑制性。

Influence factors on Synthesis and characters of temperature tolerance and salt resistance polymer KY as a flooding agent

耐温抗盐聚合物KY的合成及性能影响因素

But the reports about high salt and temperature-resistant oil displacement form system is very poor.

但是对于高温抗高盐泡沫驱油体系研究国内外鲜有文献报道。

Development and Test of a Temperature-resistant Salt-resistant Gelling Polymer Profile Control Oil Displacement System

耐温抗盐交联聚合物调驱体系的研制与试验

This paper is aiming at researching the high salt and temperature-resistant oil displacement form system under the bad field conditions.

本文主要针对高温高盐恶劣油藏条件进行泡沫体系的研究。

Application of temperature-resistant and salt-resistant ternary copolymer ( amps) in high-temperature and high salinity reservoirs

耐温抗盐的AMPS三元共聚物在高温、高矿化度油藏的应用

Improving temperature-resistant, salt-resistant and shear-resistant properties is important to the development of PAM-type products with high performances.

耐温、耐盐、抗剪切性能的改善是高性能PAM（聚丙烯酰胺）类产品研究和发展的一个重要方面。

The results showed that three fusants all had some characteristics of high temperature-resistant, salt-resistant, degrading NH3 N and NO2 N.

结果表明，3株融合子均具有耐高温、耐盐及净化养殖水体氨氮与亚硝基氮的功能。

Under the conditions of high temperature and high salinity, the temperature-resistant and salt-proof gel system featured by colloidal dispersion has been developed and prepared with the help of low concentration AM/ AMPS/ AMC14S ternary copolymer and compounded organic cross-linking agent.

在高温、高矿化度条件下，使用低浓度AM/AMPS/AMC14S三元共聚物和复合有机交联剂，制备了耐温抗盐的胶态分散凝胶体系。

It is proved that by tempering in salt bath furnace, the deformation of gear shaving cutter is small, and its dimension stability is good;

指出，盐浴炉回火，剃齿刀内孔变形小，尺寸稳定性好；

New Type High Temperature Electric Heating Salt-Bath Tempering Furnace

新型电加热管式高温盐浴回火炉

It is true that there is often a lot of salt added to prepared food, and sodium can raise your blood pressure, which can lead to a heart attack.

的确，预制食品中往往含有大量盐分，钠可能会升高你的血压，高血压可能导致心脏病发作。

It discussed the methods of increasing refrigeration of the ammonia compressor, decreasing the terminal temperature of the cold brine and the discharge of mother liquid for production of salt.

作者探讨采用增大氨压机制冷量，进一步降低混合冷冻卤的冷冻终温，提高精卤质量，降低制盐母液排放量，扩大产量，增加产值的方法，可以提高盐、硝生产的经济效益。

With the increase of terminal voltage and oxidation time the proportion of coloring salt in MAO film increased.

随着氧化时间的延长、终止电压的升高，与着色盐所形成的化合物在陶瓷层中所占的比例增大，分布趋于均匀。

Prediction and Synthesis of Ternary Intermediate Compound CsCl · MnSO_4 in Phase Diagram of Molten Salt System

熔盐相图中间化合物CsCl·MnSO4的预报与合成