TEM的例句大全

In distributed system, a computing task is often divided into several sub tasks and assigned on different processor in parallel, so as to reduce the task running cycle and improve the sys-tem throughput.

在分布式计算系统中，一个计算任务常常被分成多个子任务，然后将其分配到不同处理器上，通过并行的执行方式，达到减少任务的运行周期以及提高系统的吞吐量的目的。

The task of sys-tem level optimization is to obtain optimal system objective or multi-objective through the adjustment of global design variables.

系统级优化的任务是通过调整全局外形设计变量，使系统目标或多个目标性能最优。

Packing of the chromatin fiber of meiotic chromosomes in two species of grasshoppers under SEM TEM Multiple double-strand helical structure

应用SEM和TEM研究两种蝗虫减数分裂染色体的染色质纤维的包装&多级双股螺旋结构

By analyzing the problems of the water supply sys-tem in No.2 Steel-making Plant of Tiangang Group, the technical reformation measurement is put forth and implemented.

针对天钢第二炼钢厂板坯连铸水系统现存的问题进行了分析，提出了技术改造措施并实施。

Objective To analyse the clinical significance of acute tetramine ( TEM) poisoning.

目的分析急性毒鼠强（TEM）中毒的临床特征。

Methods The phage was identified by detection of the host range, calculation of phage plaque, negative staining for TEM, serological neutralization test and one step growth experiment.

方法采用宿主范围测定、噬菌斑计数、负染色电镜观察、血清中和试验及血清交叉中和试验、一步生长实验等技术观察分离的噬菌体。

TEM Observations of Mediate Temperature Transformation of High Nitrogen Austenite

高氮奥氏体中温转变研究

The structure of the synthesized product was discussed by XRD analysis; proved that the products belong to the Department of tetragonal anatase structure. TEM observation of samples used for the disordered morphology of mesoporous materials, can clearly see that the vermiculate ostium.

利用X-ray衍射仪进行物相分析，证明产品为四方晶系锐钛矿结构，用TEM观察样品形貌为无序介孔材料，可以很清楚地看到蠕虫状的无序孔道。

Ruthenium Tetraoxide Staining Technique of Polymer Materials for TEM

高聚物材料电镜研究的四氧化钌染色技术

In this paper, we describe the use of ruthenium tetraoxide ( RuO_4) as a staining agent for various saturated polymers for examination in the TEM.

本文系统地研究用四氧化钌（RuO4）作为各类饱和键高聚物材料的染色剂的染色条件和效果。

The results of FCM and TEM indicate that the combination of AmB plus 5-FC may enhance the sterilization effect.

透射电镜和流式细胞仪的检测结果进一步表明AmB和5-FC可以增强杀菌效果。

The discus-sion of the effect on multiplex telephone communication by noise of FM satellite communication sys-tem and microwave relay communication system is also included.

专门讨论了调频制卫星通信和微波中继通信系统中的噪声对多路电话通信的影响。

Three sets of common silicon controlled single return circuit control system was replaced by an intelligent temperature control instrument which gives good solutions to temperature control hysteresis and disturbance between two sys-tems in the synthesis of O-cresol.

用一台智能控温仪代替三套常规可控硅单回路控制系统，解决了化工试验研究中大滞后系统的控温问题和系统之间的相互扰动问题。

The microstructure and linear superelasticity of 22% cold worked Ti-49. 8at% Ni alloy has been studied by tensile test at various temperature and TEM observation.

利用透射电镜观察不同温度下的拉伸试验，研究了冷变形量22%的Ti-49.8%Ni（原子分数）合金的显微组织及线性超弹性行为。

Results of XRD, TEM, and UV/ vis spectra show that there are in-site anatase crystals contained in the sol, which are 150 nm-width squares. Thus the powders drying the sol at room temperature show an anatase pattern, without any further heat treatment.

通过XRD、TEM和UV/vis测试得知，溶胶中含有原位自生长的、边长约150nm的正方形锐钛矿晶体，所以溶胶在常温下干燥后所得粉体，无需高温热处理即为锐钛矿晶型；

The change in carbides and the recovery of dislocation structure in the matrix of tempered martensite during the process of fatigue have been studied with the help of a TEM. According to the principle of minimum energy, the interaction between carbides and dislocation was analyzed.

用电子衍衬技术研究了低碳回火马氏体在拉压对称疲劳过程中碳化物的变化及基体位错结构的回复，根据能量最小原理分析了碳化物与位错的交互作用。

The choice of right template, the mechanism of tem-plate, the structure-directing role of template and its effect on the pore size of titanosilicate sieves are also discussed.

讨论了模板剂在分子筛合成过程中的选取和作用机理，模板剂对分子筛孔道大小的影响及结构取向作用。

The dislocation microstructures in the tensile specimen of aluminium lithium alloys 2090 with addition of minor rare earth element cerium ( 2090+ Ce) were investigated by means of TEM ( electron transmission microscopy).

本工作利用TEM技术对添加微量稀土铈的2090铝锂合金（2090+Ce）拉伸试样中位错组态进行了观察。

The chemical components, structure and morphology of copolymer were confirmed by FT-IR, DSC and TEM. The surface property and mechanical properties of fluoroacrylate copolymer emulsion films were determined by water absorption ratio, contact angle and tensile testing machine.

通过FT-IR、DSC、TEM对乳胶膜组成、结构和形貌进行了表征，通过接触角、吸水率和拉力试验机表征了含氟丙烯酸酯共聚物乳胶膜的表面性能和力学性能。

Resistance to softening, the effects of alloy elements and microstructures of Cu-0.1% Ag-0.06% Ce and Cu-0.1% Ag-0.1% Cr alloys were analyzed and compared with Cu-0.1% Ag alloy, by using hardometer, electronic tensile testing machine, optical microscope and TEM, etc.

采用显微硬度计、电子拉伸试验机、光学显微镜和TEM等，通过与Cu-0.1%Ag合金对比，分析了Cu-0.1%Ag-0.06%Ce合金和Cu-0.1%Ag-0.1%Cr合金的抗软化性能、合金元素的作用及组织形貌特征。