air coolant的例句大全

The leading and trailing inserted tube for air coolant on an aeroengine is a thin wall component, it is made of Inconel 625 alloy sheet ( thickness 02mm).

航空燃气涡轮发动机前后冷气导管是一薄壁（δ＝0.2mm）零件，材质为Inconel625高温合金。

Effects of air coolant injection on cascade surface pressure distribution

冷气喷射对直叶栅型面压力分布影响的实验研究

A multi jet kidney shaped vortex system appeared on the suction or pressure side apparently by the coolant air that injected against the main stream.

叶片前缘逆主流喷射冷气使得吸力边或压力边附近出现明显的多射流卵型涡复合涡系。

A small cock or faucet or valve for letting out air or releasing compression or draining. CYLINDER BLOCK COOLANT DRAIN PLUG

放出空气或浓缩或排泄的小栓或旋塞或阀。汽缸体冷却剂放油旋塞

machine main instrument is composed of a compressor air pressure gauge, pressure gauge, coolant cooling medium low pressure gauge;

机台的主要仪表由压缩机空气压力表、冷媒高压表、冷媒低压表组成；

automotive air conditioner expendable: cooling oil, coolant, maintaining clean liquor, etc.

车用空调用品：冷冻油、制冷剂、清洁养护剂等；

Coolant temperature and ambient air pressure may be used to optimize cold starting and altitude performance.

冷却水温度和大气压力可用于使冷起动性能和高原性能最优化.

The influence of reaction temperature, coolant temperature, reaction pressure and reactor air speed was predicted.

预测了反应温度 、 冷却介质温度 、 反应压力和反应空速对加氢反应结果的影响.

Coolant mist almost always fouls the plant air and equipment.

冷却液气雾往往会污染工厂的空气和设备.

The sensors include intake air temperature mass air flow ( MAF ) , coolant temperature ( TCO ) and so on.

传感器包括 进气温度 传感器、进气压力传感器 、 冷却液温度传感器等.

Determination of Electron Density in Ar air Mixed Coolant Gas ICP

小功率空气-氩气混合气冷却ICP中电子密度的测定

In this article, the main influencing factors on condensation heat transfer include air flow rate, coolant flow rate, coolant inlet temperature and mixed gas velocity.

在本课题中，影响传热过程的因素主要有空气含量、冷却水流量、冷却水温度及混合气气速。

The method to machine the parts made of stainless steel which adopts cooled air as coolant and a little plant oil as lubricant, is studied.

对采用冷风冷却微量植物油润滑切削加工不锈钢零件的方法进行了研究。

An air flow simulating test in the coolant channel of the core bottom of the 10 MW HTR module

10MW高温气冷反应堆堆底结构中的气体流动模拟试验

The studying for the craft experiment of annotating the methyl alcohol in coolant by compression air

用压缩空气给载冷剂中加注甲醇的工艺实验研究

Investigations on the effects of various experimental parameters indicate that fuel composition, engine load, air/ fuel ratio, temperatures of coolant and oil, and testing time significantly affect the sludge formation.

指出燃料组成、发动机负荷、空燃比、冷却液和机油温度以及试验时间是影响油泥生成的重要因素。

Check air filter and coolant level;

检查空滤芯和冷却剂液位；