allowable load的例句大全

The study on the allowable axial load ratio of concrete shear wall without confined boundary elements

无约束边缘构件混凝土剪力墙的轴压比限值研究

The load carrying capacity of model bridge under the control of allowable stress is 63kN;

在容许应力控制下模型桥的承载力为63kN；

On the basis of experimental and theoretical studis, formulas for predicting load capacity and normal service allowable maxi ─ mun torque are presented.

根据理论和试验研究，提出了承载力和正常使用允许最大扭矩的计算公式。

the allowable pile bearing load is prestimated, and the outcome is in conformity to static pile test.

并以分析结果为依据，预估单桩承载力，结果与静力试桩结论相吻合。

The allowable pile bearing load is prestimated, And The outcome conformity to static pile test.

并以分析结果为依据,预估单桩承载力, 结果与静力试桩结论相吻合.

The cause of externally applied pipe load to brazed aluminum heat exchanger and the necessity of calculating allowable pipe load are analyzing.

分析了板翅式换热器封头接管外载荷产生的原因和进行许用接管载荷计算的必要性。

Maximum permissible amount ( MPA) The model is known as the maximization of total allowable waste load, subject to meeting water quality standards at checkpoints along the river.

模型以总的允许排污量最大为目标函数，流域的水质控制点达标为约束条件。

For the traditional Doherty power amplifier, the current of the peaking amplifier could not get to the maximum allowable level that the load modulation of both amplifiers was unable to achieve the optimized impedance at the maximum output and resulted in the efficiency degeneration because its low bias.

对于传统Doherty放大器，由于峰值放大器偏置的原因使其在最大输出工作状态时，无法达到最大电流而导致两个放大器的输出端无法实现最佳负载调制，造成整体效率下降。

The points out that the following should be followed to reduce tire wear: ensure tire normal air pressur and normal allowable tire load, assure optimum front wheel alignment parameters, design rational steering mechanism, increase integral torsional rigidity of the truck and its body.

指出，为减少轮胎磨损，应从以下几方面着手：保证轮胎正常行驶气压及允许裁荷、寻找最优前轮定位参数、设计合理的转向机构、提高整车和车箱的整体扭转刚度。

The allowable settlement of pile head is suggested and vertical pile can bear load with inclination of less than 10 °, and batter pile bearing vertical load can be angle of less than 10 °.

以桩顶沉降控制作为桩基承载力设计的标准，认为直桩可以承受小于10°倾角的倾斜荷载，承受竖直荷载的斜桩可以有小于10°的倾角。

By analyzed interactions of combined limit pipe load components, simplified check formula for pipe load strength are put forward and the calculation method of relevant allowable pipe load values based on shell finite element analysis is presented as well.

通过对组合极限接管载荷分量相互关系的分析，提出了接管载荷强度验算简化公式和以壳结构有限元应力分析为基础的许用接管载荷计算方法。