angular error的例句大全

The requirement for the angular error between the incident and the reflecting ray is about ± 10 arc second.

入射光线经五折镜组件反射后出射的角度误差为±10〃。

In this paper, the effect of the site errors on the Lightning Direction Finder has been analyzed. The angular error produced by re-radiated field caused by isolated is estimated.

分析了站址环境对雷电定位系统中的方向探测仪的影响，定量估计了孤立障碍物产生的二次辐射场引起的定向误差的大小，分析了方向探测仪周围的输电线路对定向产生的误差。

we make in-depth analysis of the positioning errors of the underwater benchmark due to cylinder deformation, positioning error of gps, angular error of compass, and measurement error of the dynamic motion sensor.

通过详细分析了水下基准安装柱扰曲形变、GPS定位误差、罗经测向误差、纵倾横摇角测量误差对高精度定位标定系统水下基准位置的影响。

Angular Error Measuring Technology of Tank Gun Stabilizer

坦克火炮稳定器的误差角测量技术

Angular calibration of radar antenna system is composed of the calibration of angular error sensitivities ( also called directional sensitivity), adjustment of cross-coupling of azimuth and elevation signals, and the calibrations of system errors such as antenna axial system error, dynamic delay and so on.

雷达系统天线的角度标校包括对系统角误差灵敏度（又称定向灵敏度）的标定、方位俯仰信号交叉耦合的调整以及对天线轴系误差、动态滞后等系统误差的标定。

Error signals are decomposed and reconstructed by db3 wavelet. reconstructed normal variation is less than angular measuring system precision, reconstructed signals are used to compensate the system errors instead of original error signals.

采用db3小波对测角系统误差信号进行分解与重构，重构标准差小于测角系统精度，重构信号满足精度要求，可以用重构信号代替原误差信号进行计算机误差补偿。

Use the "limit value method" to calculate the locating error of the workpiece during the pin touches the arbitrary edge of the locating hole and find out the value and rule of the error in angular direction.

本文应用极值法对定位销与定位孔的任意边接触时的定位误差进行了计算分析。

theory research on angular misalignment error models of inertial instrument

建立惯性仪表安装误差数学模型的理论研究

a method by combining the measured radial data performed on the three orthogonal panes in the machine work zone with the volumetric error models to identifying parametric errors such as positional, straightness, angular, squareness, and backlash errors is given in detail.

给出了在机床工作空间中三个互相垂直的平面内，用球杆仪测量圆周运动的半径误差结合机床的空间误差模型识别定位、直线度、角度、垂直度和反向间隙等误差参数的方法。

Traditional coning compensation algorithm error greatly increased while angular velocity signal was algorithm input.

以角速率信号作为算法输入时,采用以往常用的圆锥补偿算法,算法误差明显增大.

By analyzing error . the angular precision of this turntable is about . 0.75 %.

经误差分析,所研制装置的转角精度约为0.75%.

By using the signal analyzing technology to deal with signals read by two read heads of the angular indexing measuring system, the harmonic errors caused by main error resources of the measuring system can be detach and correct.

通过应用信号分析技术对圆分度测量系统中适当布置的两个读数头的读数信号进行分析处理，可分离出由测量系统主要误差源引起的前几十阶读数谐波误差并予以修正。

The equation of dynamics of bifilar pendulum has been sol-ved in this paper. The formulas to calculate free swing period under small and large angular amplitude conditions are given, and error analysis is discussed briefly.

本文求解了双线摆的动力学方程，得出了计算小角度摆动和大角度摆动时双线摆动周期的计算公式，并进行了误差分析。

The test results show that the basic error, linearity of the capacitive angular sensor can be more effectively improved than before. The average of the former decreases from 2% to 0.2%, and the later from 0.58% to 0.22%.

测试结果表明，利用本系统校准，电容转角传感器的基本误差、线性度指标都得到有效改善，前者平均值从2%降低至0.2%，后者由0.58%降至0.22%；

Paper analyzes the the attitude update algorithms of local level frame, and studies the projection error of angular rate of navigation reference frame relative to inertial frame under the large angular motion dynamic environment.

论文分析了当地水平地理坐标系下的姿态更新算法，研究了大角运动动态环境下，导航参考坐标系相对惯性系转动角速度在载体坐标系下的投影误差影响。

Angular measuring system error compensation based on wavelet analysis

基于小波分析的测角系统误差补偿研究

Error analysis on linear accelerometer-assisted inertial angular position measurement

线加速度计辅助惯性姿态角测量的误差分析

And the error of linear speed and angular rate are also given.

并给出各种组合导航系统水平通道速度、姿态角的稳态误差。

The current loop technique improves the stabilization bed ability to reduce base disturbance direct drive constraint couple and enhances the torque sturdiness. The stabilization error is reduced with current loop technique under same base angular disturbance.

在转台稳定系统中使用电流环技术，提高了转台对直接带动约束耦合的抑制能力，提高了系统的力矩刚度，在同等的扰动条件下，降低了稳定误差。

A number of factors having effect on the accuracy of rotary axes, such as radial runout and angular swing, are discussed, and a quantitative analysis has also been made for the axial shaking error resulting from the form and position errors of the rotary axis components.

讨论了影响轴系旋转精度的诸多误差因素，如轴向窜动误差，角度摆动误差等，并定量分析了构成轴系零件的形位误差引起旋转轴系在回转运动中的晃动误差。