bending point的例句大全

According to the analysis of experimental data, based on the theoretical model of composite, we can get a theoretical tensile curve of specimen and the theoretical deflection curves on 3-point bending load bending, then compared them with experimental data respectively.

分析实验数据，并根据复合材料理论分析模型，得出试件理论拉伸曲线和三点弯曲载荷下的理论挠曲线，分别与实验数据进行比较。

Based on the results of four-point bending tests of 14 RC test beams with different areas of CFRP strips, areas of steel tension bar and different lengths of CFRP, this thesis studies the flexural performance of the RC beams with near surface mounted CFRP strips.

本文对14根钢筋混凝土梁试件进行了四点弯曲加载试验，考虑加固量、纵筋配筋率和嵌贴长度的影响，重点研究了表层嵌贴CFRP板的抗弯加固承载力。

The analysis of a four-point bending test of box girder specimens shows favourable agreement with experimental data.

对箱形桁材的四点弯曲试验的分析表明与试验数据吻合良好。

This paper describes the performance test, contact fatigue strength test and bending fatigue strength test on the gear reducer of involute point contact Ferrographical analysis is made.

本文对渐开线点啮合齿轮减速器进行了性能试验、接触疲劳强度和弯曲疲劳强度试验，同时还进行了铁谱分析。

Under the conditions of the same internal pressure, with the relative bending radius increased, ellipticity and the thickening rate of internal measuring point decreased; the thickening rate of outer measuring point gradually were also decreased.

在充液压力相同的条件下，随着相对弯曲半径的增加，椭圆度逐渐减小；内侧点的增厚率逐渐减小；外侧点的减薄率逐渐减小。

Spline finite point method for bending analysis of thin slab

薄板弯曲问题分析的样条有限点法

The slip between the threaded rod and concrete is little in the three-point bending test, indicating that the selected threaded rod and the torque applied to the nut before loading are acceptable in practical applications.

在加载过程中，螺杆与混凝土之间的相对滑移量很小，因此在拉拔试验中选择的螺杆以及施加于螺母的扭矩在实际工程中是适用的。

Double-K Fracture Parameter of Concrete and Its Size Effect by Using Three point Bending Beam Method

三点弯曲梁法研究砼双K断裂参数及其尺寸效应

The Loading Capacity of Three Point Bending Beam With the Resistant Force of Cohesive Crack

黏聚裂纹阻抗的弯曲梁承载力

The Double-K Fracture Parameter of Concrete for Non-Standard Three Point Bending Beam Specimens

砼非标准三点弯曲梁试件双K断裂参数

Sress Intensity Factors for Cracked Three Point Bending Specimen of Functionally Graded Materials

功能梯度材料开裂三点弯曲试件的裂纹端应力强度因子

Dynamic crack tip open displacement COD and a crack extension Δ a for three point bending specimen are obtained by calculating.

通过计算得到三点弯曲试样的动态裂纹尖端张开位移COD以及动态裂纹扩展量Δa，在此基础上得到裂纹动态起裂点。

An application of the finite difference method to the propagating crack and fracture problems in the three point bending specimen of concrete is presented on the basis of the fictitious crack model.

本文用有限差分法于虚拟裂缝模型，分析了混凝土三点弯曲切口梁中裂缝的扩展至断裂的全过程。

Combining experimental and numerical simulation methods, the effects of weld-joint strength matching on the crack tip opening displacement ( CTOD) of three point bending specimen are investigated.

利用试验研究和数值分析方法，对模拟焊接接头三点弯曲试样不同强度组配对裂纹尖端张开位移（CTOD）的影响进行了研究。

In this paper, a simple formula is derived for calculating the dynamic stress intensity factor ( DSIF) of three point bending specimen using dynamic crack opening displacement ( DCOD).

给出了一种由裂纹的动态张开位移计算三点弯曲试样的动态应力强度因子的简单方法。

The distributions of stress and strain ahead of a precrack tip in three point bending specimen are calculated by finite element method and the fracture surfaces, the micro-cavities and micro-cracks in the vicinities of the precrack tip are also observed.

对三点弯曲预裂纹试样断口形貌、裂尖附近微孔及残留裂纹进行了观察，并用有限元方法计算了裂尖应力应变场。

On the Crack Tearing Propagation in Three--Point Bending Specimen

三点弯曲试样裂纹撕裂扩展的研究

Having succeeded in building up an exercise model, the three point bending experiment was conducted on the left femur to determine the effects of different training load on bone biomechanics.

在成功建立骨质疏松大鼠运动模型基础上，将大鼠左股骨进行3点弯曲实验，对不同强度运动下的骨生物力学性能变化进行了比较研究。

In this paper an expression of flexural rigidity and stress of FRP concrete composite pipe is put forward. Furthermore, the experimental verification is made with its flexural stress and deflections, measured by three point bending experiment.

本文导出玻璃钢/混凝土复合管的弯曲刚度与应力计算表达式，并以三点弯曲试验测出复合管的弯曲应力和挠度来验证。

In this paper, the ten-year-old loblolly's shear moduli, GLT, GLR, were tested by the variable span method in the three point bending experiment, while GRT was measured by a compressing test with 45 ° bias-axis.

研究采用变跨距的三点弯曲方法测试10年生火炬松木材17号家系和50号家系的剪切弹性模量GLT，GLR值；用45°偏轴压缩法测量GRT值。