binder content的例句大全

The effect of the binder content and the second activat temperature on properties of activated carbons in pellet such as the compressive streng bulk density and gasoline adsorption were investigated.

考察了黏结剂添加量和二次活化温度对成型活性炭强度、堆积密度、油气吸附性能等影响。

The propagation rate of crack also decreases with increasing the binder content of cermets.

随着金属陶瓷中金属相含量的增加,裂纹扩展速率降低.

New Method to Calculate Initial Asphalt Binder Content for Stone Matrix Asphalt

沥青玛蹄脂碎石初始沥青用量的计算方法

Different body molding pressure, optimal value ceramic binder content is different.

不同的坯体成型压力下，陶瓷粘结剂含量最优值是不同。

It was shown that, complex figure W-skeleton with homogeneous porosity distribution can be obtained with 35% ( in volume) binder content and high temperature.

结果表明，添加35%体积分数的粘结剂并在压制过程中提高压制温度会明显改善钨骨架孔隙度分布的均匀性；

SiC powders were treated by spray pelletization, and the influences of processing conditions and binder content on the crushing behavior of SiC granule during compaction were investigated.

采用压力喷雾造粒的方式对SiC粉体进行喷雾造粒处理，研究了喷雾造粒过程中工艺条件和浆料中粘合剂含量对成型过程中粉料颗粒破碎行为的影响。

Relationship between resin binder content and properties of automotive friction materials

树脂粘结剂含量对汽车摩擦材料性能的影响

Experimental results indicate that the optimized binder content and ingoing temperature of airflow are 50 ml/ kg and 240 ℃, respectively.

SiC粉体在喷雾造粒时最佳粘合剂含量和进口热风温度分别为50ml/kg和240℃。

In addition, this manuscript studies different influence that cements with different SO_3 content give sand-cement grout, cement-fly ash binder, cement fly-ash stabilized hoggin and probe the action that SO_3 appears in different material system.

此外，本文还通过研究不同SO3含量的水泥对胶砂试块、水泥粉煤灰结合料以及水泥粉煤灰稳定碎石材料的强度性能的影响，探讨SO3在不同材料体系中的作用。

The low content of clay is the main reason that the performance of the soil stabilized with inorganic binder is poor.

研究认为，粘粒含量低是无机结和料稳定该类土性能差的主要原因。

The influence of carbon content. nickel content in binder and temperature on the thermal diffusivity of WC-Co-Ni hard metals were studied.

本文研究了配碳量、粘结相中镍含量和温度对WC－Co－Ni硬质合会热扩散事的影响。

The extent to the effect of types and content of mineral admixtures on ARH reduction of concrete resulting from self-desiccation can be reflected by the parameter of the effective water to binder ratio r_e effectively.

有效水胶比re可有效地反映不同龄期下矿物掺和料种类和掺量等变量对混凝土自干燥效应的影响程度。

The experimental results showed that the bonding performance of the soil binder was related to its gel SiO_2 content and structure of the noncrystalline phase.

结果表明：土壤粘合剂粘结性能与SiO2溶胶数量及结构性能有关。

Using the blend of epoxy resin and phenolic resin as binder, whose functional group molar ratio was 1:3, and the total resin content was 17wt%.

粘结剂使用EP和PF的共混树脂，其官能团摩尔比为1：3，总树脂含量为17wt%。

A Study on Relationships between the Growth Status of Dominant Sand Binder Seedlings and Water Content

固沙植物苗木生长与沙地水分的关系

The synthetic process of polyurethane elastomer binder for magnetic tapes is introduced. The influences of water content in the raw materials, reaction temperature, the ratio between NCO and OH in mole and polyester molecular weight on the synthesis of polyurethane are also discussed.

介绍了聚氨酯弹性体磁带粘合剂的合成工艺，讨论了原料含水量、反应温度、n（NCO）：n（OH）及聚酯分于量对聚氨酯合成的影响。

At the condition of addition of organic binder, the optimum FeO content control limit of 8%~ 10% was proposed.

烧结矿FeO含量的变化规律，提出在添加有机粘结剂的条件下，FeO含量最佳控制区间为8%～10%。

Coupling agents have important effects in the aspect of increasing the compatibility between ceramic powder and organic binder, and can induce viscosity and improve ceramic solid content of the slurry.

偶联剂能够增加陶瓷粉体和有机载体的相容性，起到降低浆料体系粘度和增加陶瓷固相体积分数的作用。

Effects of Grain Size and Content of AgBr on Sensitivity of PTG Materials Using PVA as a Hydrophilic Binder

AgBr的尺寸及含量对PVA为粘合剂的光敏热成像材料的光敏性的影响

Variation of sinter FeO content after addition of HPL organic binder in sinter mix

添加HPL有机粘结剂后烧结矿FeO含量的变化