boiler end的例句大全

In this paper, the wall-temperature working state of each bank of finned tubes on a working condensing heat exchanger were calculated by finite element method, which was on a gas fired boiler end.

用有限差分法对一台已在燃气锅炉尾部运行的冷凝换热装置的各排翅片管束的壁面温度进行了计算。

Study on the flue gas spray and wet enhancement technology in the flue of a boiler end part

锅炉尾部烟道直接喷水调质技术的研究

Some suction is provided by the ejector scrubber and the tail gas fan. Study on the flue gas spray and wet enhancement technology in the flue of a boiler end part

喷射洗涤器和尾气排风机可提供部分吸力。锅炉尾部烟道直接喷水调质技术的研究

I saw the water boiler at the end of the car.

我在车厢的尽头那边看到有一个自动热水器。

Practice proved that the change in the overheater end connection from cross arrangement to parallel arrangement can increase the air preheater inlet fume temperature, principal steam temperature and reheated steam temperature, and reduce the thermal deviation of overheater, and improve the efficiency of boiler.

实践证明，通过调整对流受热面面积，将过热器末段间连接交叉布置改为平行布置，能够提高空气预热器入口烟温、主汽温和再热汽温，降低过热器热偏差，提高锅炉效率。

through study on pipe end shrink mouth technology of 300 mw, 600 mw boiler heated surfaces made in harbin boiler works as well as analysis of principle of pipe end shrink mouth and technology design, a new method of shrink mouth technology and parameters are proposed.

通过对哈尔滨锅炉厂300MW、600MW锅炉设备等受热面管子管端缩口工艺的研究和对管端缩口基本原理、工艺设计原则的分析，提出了缩口工艺新方法及工艺参数。

study on pipe end shrink mouth technology of boiler heated surfaces

对锅炉受热面管子管端缩口工艺的研究

According to the practical issues encountered in boiler inspection the stress analysis method is applied in analytic error calculation of small end of conical head with half top angle> 60 °. Analytic checking calculation shows that error is in allowance range.

针对在锅炉检验中常遇到的实际问题，应用应力分析法，对半顶角大于60°锥形封头的小端解析误差进行了计算分析，并经解析式验算，指出其误差在工程允许范围内。

When being installed, the front end of the feeding pipe is inserted in a boiler furnace.

安装时将送料管前端头插入锅炉的炉膛中.

Additional load carrying capacity required for the cross bracing systems in the two end transverse frames of the boiler framework is presented.

为保证中间框架压杆的稳定，对构架两端部横向框架交叉支撑体系也提出了附加的强度要求。

The abrasion of utility boiler back-end surface is a widespread problem.

燃煤电站锅炉尾部受热面磨损是火力发电厂普遍存在的问题。