breaking stress的例句大全

The results showed that tensile strength, tensile yield stress and tensile breaking stress were increased with the increase of bore distance;

结果表明，随筛板孔距的增加，其拉伸强度、拉伸屈服应力及拉伸断裂应力均提高；

Conventional yield stress, breaking stress and breaking extensibility of the blends with different proportions were also measured.

测定了共混物的屈服应力、断裂应力和断裂伸长率。

The influence of thermal oxygen on the tensile yield stress, tensile breaking stress, impact strength, elongation at break, melt point and the heat of melting of PF Nylon 1212 is investigated.

通过热氧老化试验，考察了热氧对尼龙1212拉伸屈服应力、拉伸断裂应力、冲击强度、断裂伸长率、熔点、熔融热的影响。

It was found that the breaking stress decreased with decrease of molecular weight and degree of macromolecular orientation.

研究结果表明，本文工艺条件下研制的PDS缝线在体外降解过程中随着分子量和大分子取向程度下降，力学性能明显下降，4星期时强度基本消失。

It was found that the breaking stress decreased with decrease of molecular weight and degree of macromolecular orientation. The exPeriment show that the macromolecular orientation degree 0f the new material varies with silk reeling pmeesses;

对于采用不同缫制加工工艺制得的各种真丝新材料，其材料中大分子取向程度亦不相同。

The ratio of the breaking stress of a structure to the estimated maximum stress in ordinary use. The Effect of Maximal Pressure and Roll-gap on Energy Consumption of Roller Press

间断压力同最大压力的比率。最大压力与辊隙对辊压机能耗的影响

The results showed that the critical fracture load of passive films reduced and the displacement excursion decreased with increasing the concentration of hydrogen. The reduction of radial breaking stress and elastic modulus of passive films is attributed to that hydrogen changes the structure of passive films.

结果表明：随氢含量的增加，不锈钢钝化膜的临界破裂载荷降低，位移偏移量减小，氢导致钝化膜的径向抗拉强度（应力）和弹性模量降低，钝化膜随氢含量的增加而逐渐软化。

Based on the studies above, the prediction models of breaking stress and breaking elongation are explored primarily.

基于上述对浆纱耐磨性和浆纱结构的研究，对浆纱断裂强力和断裂伸长率预测模型进行了初步的探索和研究。

Slab breaking induced by thermal stress;

温度应力引起的断板；

Nearly 50% of workers close to 'breaking point' due to stress

近一半的上班族因为压力太大而濒临崩溃

The fracture stress and Young's modulus are decided by draw ratio and independent of our set drawing temperature, however breaking elongation is decided by the both.

纤维的断裂强度与杨氏模量主要由拉伸倍率决定，断裂伸长率则由拉伸倍率和拉伸温度决定。

The phenomena mentioned presumably srises because of the synergistic effect of increasing of breaking elongation by BPA and of yielding stress by multifunctional rubber.

这可能是由椽胶提高断裂伸长与双酚A提高屈服应力产生协同效应的结果。

When the pressure reaches the breaking pressure, along the direction of the arrangement hole, the Y-direction tensile stress exceeds the tensile strength of the rock, so rock fracture.

当压力达到破坏压力时，模型沿布置孔的方向的Y方向拉应力超过了岩石的抗拉强度，岩石破裂。

The calculation includes theoretical stress on breaking face of the mineral crystal material and theoretical tensile strength of the mineral fibrious material.

计算分矿物晶体材料断裂面上理论应力（解理应力）与矿物纤维材料理论抗拉强度两部分；

bottomhole stress analysis and breaking mechanism research in underbalanced drilling

欠平衡钻井井底岩石应力状态分析和破碎机理研究

Folding force apparatus used in ampoules, afterburning, record breaking up ampoule under stress.

用安瓿折力仪加力,直至安瓿断裂, 记录下折断力值.

Many are breaking down these days due to working stress.

许多人因为事情压力而垮了.

Under laboratory conditions, after calcined at the temperature of 700 ℃, red-mud is mixed with cement to produce a special kind of concrete, with which the standard concrete is compared in terms of breaking and stress intensity.

在实验室条件下，对赤泥进行700℃的煅烧处理，并利用其制取水泥赤泥混凝土，与基准混凝土的抗折、抗压强度进行对比。

as eurocrats in brussels are keen to stress, far from breaking up, the euro zone is growing.

布鲁塞尔的欧共体官员热衷于强调，欧元区正在扩大，远没有分裂。

STRESS AND FLEXIBILITY CRITERIA OF BENDING AND BREAKING IN A COUNTERTENDENCY LAYERED SLOPE Experimentation research on factors influencing stability of anti-dip layered slope

反倾层状边坡弯曲折断的应力及挠度判据对影响逆倾层状边坡稳定性因素的模型试验研究