buckling load的例句大全

Furthermore , the larger diameter of case rear aperture is, the greater critical buckling load is.

壳体后开口直径越大, 临界屈曲载荷越大.

the critical buckling load for the earth auger of drill shaft fixed on the elastically restraint system

固结于弹性约束系统上的挖坑机钻头主轴的临界屈曲载荷

The elastic buckling load of axially loaded compression steel pipes strengthened with FRP was presented in this paper by using energy approach.

采用能量法推导出FRP加固轴心受压钢管的弹性屈曲荷载计算公式。

for a primary buckling load, the limit load carried capacity of the arch of 0.23 ratio-span is the biggest one under a half span load distribution and that of the arch of 0.1 rise-span ratio is the biggest under a full-span load distribution.

对于材料、截面相同，矢跨比0.1~0.5的拱，半跨均布荷载作用下矢跨比0.23的拱极值点屈曲极限承载力最大；

The prosperous post buckling load capacity of web plates of box girders can be used.

焊接箱形梁腹板存在较高的屈曲后强度,可供利用.

Energy method for buckling load of wall studs in cold-formed lower house

冷弯型钢房屋墙体立柱临界屈曲荷载能量解

Then, in the original state without damage, the impacts of parameters of the ribs height, thickness, and interfacial strength on the buckling load and ultimate strength of stiffened composite plates are discussed using the RIKS method.

然后在原始无损伤状态下，通过引入屈曲模态，探讨了筋条高度、宽度参数等对复合材料加筋板屈曲载荷和极限强度的影响。

A rational method is presented for calculating the ultimate strength of the pressure hull plate and the buckling load of the tank shell.

提出了液舱区耐压船体壳板极限承载能力及波舱壳板失稳压力的计算方法。

for a secondary bifurcation buckling load, the limit load carried capacity of the arch of 0.1 rise-span ratio is the biggest one under a full span load distribution.

全跨均布荷载作用下，矢跨比0.1的拱极值点屈曲和二次分岔屈曲极限承载力均大于其他拱。

The computation of elasto plastic buckling load displacement response curves for plate and shell structures

板壳结构弹塑性屈曲问题载荷&位移响应曲线的计算

Compare the static compression properties of unidirectional and laminated specimen, it is found that the local and global buckling force of unidirectional specimen are higher than laminated specimen; while the local and global buckling load displacement of unidirectional specimen are lower than laminated specimen.

比较单向板和层合板静压缩性能，可得：单向板的局部屈曲和整体屈曲载荷均高于层合板；而单向板的局部屈曲和整体屈曲加载位移均低于层合板。

The critical buckling load is influenced by the pattern of bottom-hole assembly directly.

下部钻具组合的具体方式将直接影响其所能承受临界失稳载荷的大小.

Height of columns, concrete grade and area of section are some factors considered when analyzing buckling load. ( 4) According to the completed results of this paper, the suggestion for the design theories and seismic design of the structures with specially shaped columns are given.

分析了柱高、混凝土强度等级、柱截面面积对屈曲荷载的影响。（4）根据文章所完成的研究成果，给出了异形柱结构体系设计理论与抗震设计的具体建议。

A general eigen function was deduced for computing global buckling load combined with a Rayleigh-Ritz method.

结合Rayleigh-Ritz能量近似法，推导出了求解加筋板总体屈曲载荷的通用特征方程；

The analysis of buckling load of the horizontal drill stem

水平钻柱屈曲载荷的分析计算

A Study on the Strength and Buckling Load of Steel Bracket Plates

钢承托板的强度和屈曲承载力的研究

The results showed that an increase in cutout dimension will not necessarily reduce the buckling load in specific situations.

结果表明在某些特定情况下增加孔径不一定会降低板的屈曲载荷。对于特定长宽比和边界条件的板，压缩载荷可能随孔径的增加而增加。

the analyses of critical buckling loads of triangulated lattice dome structures under uniform load conditions

均布荷载下三角网格圆锥壳的临界屈曲荷载分析

Study on Dynamic Buckling of Axial Compression Member under Impact Load

冲击荷载作用下轴心受压构件动力屈曲研究

Calculation of lateral buckling critical load of crossbeam on frame for hoisting blowout preventer. CPM

封井器吊装架横梁的侧向屈曲临界载荷计算