c cm的例句大全

The results showed that C, Mn and V elements in steel had no effect on the behavior of N in vacuum condition: denitrogen was first-order reaction with mass transfer rate coefficient 0.091 cm/ s.

结果表明，在真空条件下，钢水中的C、Mn、V对N的行为基本没有影响，此时脱N为一级反应，传质速率常数为0091cm/s；

The depth from skin to the nerval root C 7 is 3.26 ± 0.59cm;

皮肤至7颈神经根的深度为（3.26±0.59）cm；

the aph ( 3') inhibitor 85& 39 was isolated by precipitation with acetone from the broth filtrate and then extracted with distilled water. the active component was purified by column chromatography on cm-sephadex c-50 ( nh_4~+ form).

分别采用丙酮沉淀、硫酸铵分步沉淀和柱层析技术从链霉菌8539发酵液中分离、纯化出APH（3′）抑制剂8539，并对其部分理化性质进行了测定。

an experiment has been made to cure oligomer trihydroxy methyl propane tri acrylate ( tmpta) in sds-ii at ( 20 kv) and 2_c/ cm~ 2 dose.

在此基础上使用SDS-II型曝光机在20kV的加速电压、2μC/cm2的曝光剂量下，对经真空挥发处理过的三羟甲基丙烷三丙烯酸酯（TMPTA）液态低聚物进行了曝光试验，得到了固化结构。

The substrate temperature has great influence on the properties of both the SiO_2 films and the SiO_2/ Si interface. The fixed charge density of the SiO_2-Si system is estimated from the C-V curve, the minimum value is about 1.73 × 10 10 cm-2.

SiO2薄膜中固定氧化物电荷密度受衬底温度影响较大，其最小值可达1.73×1010cm-2。

The remnant polarization ( Pr) and effective dielectric constant ( Kef) is about 13 μ C/ cm 2 and 1 380 at 8V, respectively, it is most like PZT film on Pt.

8V时膜的有效介电常数Kef约1380，剩余极化强度Pr＝13μC／cm2，与Pt衬底上无明显差别。

In the experiment, the compacted clay liner systems in Columns A, ( 100% clay) Column C ( 10% zeolite+ 90% clay), achieved hydraulic conductivity values of the order 10-7 cm/ s which is the maximum limit permitted by most countries.

实验中，A柱（100%粘土）和C柱（10%沸石＋90%粘土）防渗系统的渗透系数均达到了大多数国家承认的10-7cm/s数量级的最低标准。

4) the internal surface area of the alveolar capillary bed ( S_C) was 3525.05 ± 569.91cm~ 2;

4）肺泡毛细血管床内表面积（Sc）：3525.05±569.91cm~2/左右肺；

Fruit clavate, c. 1.5 cm long, 0.4 cm wide.

果棒状,长约1.5厘米, 宽0.4厘米.

The change content of soil organic C and N mainly occurred within soil depth of the 0-40 cm.

土壤有机C、N的含量变化主要发生在0-40cm土层。

C/ C composites with density as high as 1.74 g/ cm 3 were obtained within 3 hours by the new process. Carbon felt disk preforms have been densified in a liquid carbon source. The liquid precursors studied in the present work include CYH and KEE.

利用该技术，采用碳毡作预制体，以两种液态低分子有机物作碳源前驱体，沉积时间在3h内，沉积温度在900℃～1100℃范围内可获得密度达1.74g/cm3的C/C材料。