connecting bolt的例句大全

the belt allows you to easily bolt it into position without connecting to the vehicle's anchor points.

安全带允许您轻松将其扣紧到位，而无需连接到车辆的固定点。

The Squeeze Technology of Making Threaded Hole for Connecting Rod Bolt

连杆螺栓孔螺纹挤压工艺

Scoring of Connecting Rod Bolt Bearing Surface and Its Improvement

连杆螺钉支承平面的咬毛及改进措施

Wave equation of variable cross-section, a half-wavelength transducer oscillator and half-wavelength horn are designed respectively, using Boundary-Condition Method and Transfer Matrix Method, which develops a whole-wavelength power collected transducer by connecting the two parts with a bolt.

基于一维变截面杆纵振波动方程，采用边界条件法和传输矩阵法分别设计了半波长换能器振子以及半波长变幅杆，二者通过螺钉连接组成全波长聚能型压电换能器。

To improve the stiffness of demountable steel structures and reduce their inelastic deflections caused by pin ( or bolt-hole displacements), We study and produce a new type of connecting components, expending tapered pin.

为提高拆装式钢结构整体刚度，减小拼组结构的非弹性销（栓）孔变位挠度，研制了一种新的连接件&充盈式锥形钢销。

Reasons and treatment of break of bolt connecting drive hub and drive teeth of plate feeder

板式给矿机驱动轮毂与齿间连接螺栓断裂的解析及处理

The pressure device is fixed at the tail end of a carriage bottom and the lock bolt is connected with the connecting rod of the pressure device;

压力装置固定于车厢底部末端处，锁舌连接在压力装置的连杆上。

the test& research on connecting behavior of high strength bolt for medium thick plate

中厚板高强度螺栓连接性能试验研究

The Calculation and Analysis of Dynamic Characteristic of the Diesel Connecting Rod Screw Bolt

柴油机连杆螺栓受载动态特性的计算分析

when the connecting piece is screwed down by a bolt, the clapboard is fixed corresponding to the position of the upright post;

当连接件被螺栓拧紧时，该载物隔板相对于立柱的位置固定；

the clamping ring is circular and is fixed on the upright post through a connecting plate and the lock bolt.

卡环为圆形，通过连接板和锁紧螺栓固定在立柱上。

a connecting plate (17) and a bolt (18) realize linkage between the sliding plate and the door latch;

实现滑板与门拴连动的是连结板（17）及螺拴（18）；

the lower part of the socket cavity is clamped between the outer and inner connecting plates, and is fixed by the countersunk bolt.

所述的外连接盘与内连接盘将接受腔下部夹持在中间，并通过沉头螺栓螺合。