constant current的例句大全

The approach is designed a group of temperature controlled switch circuit which control whether the parallel resistance is activated or not. Temperature signal is come from bridge voltage signal which is power supply by constant current source.

技术途径是设计一组温控开关电路来控制并联电阻器是否接入，温度信号来源于恒流源供电下的传感器桥压信号。

Through constant current charge-discharge experiments and NEDC, FUDS, DST conditions cycle experiment on nickel-hydrogen batteries, the impact of accumulated measurement error of current sensor on Ampere-hour method is studied.

通过对镍氢电池进行恒流充放电实验和NEDC、FUDS、DST工况循环实验，研究长时间运行时电流传感器的测量误差对安时法估计SOC的影响。

The anatase and rutile TiO_2 porous films were prepared directly on the surface of pure titanium by constant voltage and constant current anodic oxidation using sulphuric acid, pure titanium and pure copper as electrolyte, anode and cathode, respectively.

以硫酸为电解液，纯钛（TA1）为阳极，铜片为阴极，以恒压和恒流阳极氧化方式在钛表面直接获得锐钛型和金红石型TiO2多孔膜。

Study of a solar constant current controller

一种太阳能恒流控制器的研究

The electrochemical properties of spinel LiMn 2O 4 electrodes prepared by a sol gel method were studied by cyclic voltammetry, constant current charge discharge and electrochemical impedance spectrum ( EIS) techniques.

利用循环伏安法（CV）、恒流充放电、电化学阻抗谱（EIS）等电化学手段研究了溶胶凝胶法制备的尖晶石型LiMn2O4的电化学性质。

Development of constant current controlled soft-switch power for spot welding

恒电流控制软开关点焊电源的研究

A Reserch on LC Resonant Constant Current Charging Power Source

LC谐振式恒流充电电源的研究

Comparing with constant current-constant voltage charging mode, pluse charge technology have shorter charging time, higher charging efficiency and lower temperature increasing during the charging process.

实验表明：与传统的恒流-恒压充电技术比较，脉冲充电技术具有充电时间短，充电效率高的优点。

Research on alternating constant current drive systems for high-power load;

介绍一种全数字控制的高性能交流主轴伺服驱动系统。

This paper introduces a high-frequency series resonant charing method of solid pulsed laser power source, basing on constant current charging of digital control technology.

介绍了一种高频串联谐振充电的固体脉冲激光电源及其数字化控制恒流充电技术。

In order to improve the performance of thermal conductivity detector ( TCD) for gas chromatography, a precision constant current source circuit and a difference voltage detection circuit were designed.

为了提高气相色谱仪用热导检测器的性能，设计了热导检测器的精密恒流源和差压检测电路。

A new method for determination of electrical parameters in Silicon chip and MOS properties by the constant current transient technique is described.

本文提出了利用恒流瞬态技术测量硅片电学参数及MOS特性的新方法。

Mainly through the voltage regulator chip, integrated operational amplifier, a programmable constant current source which is voltage-current mode is designed. When the current of constant current source flows through the gas sensor, the resistance signal of the sensor can turn into standard-voltage acquisition signal.

主要是通过稳压芯片，集成运放设计一个电压转电流型程控恒流源，恒流源的电流流经气体传感器，把传感器的电阻信号转换成标准的电压采集信号。

The driving IC can drive up to six white LEDs in series with a constant current to provide display backlighting for two ( main and sub-) displays in cell phones and other portable devices.

该驱动IC可恒流驱动多达6个串联的白光LED，而且可以为带有主/次显示屏的手机等便携式设备提供灵活的背光控制。

Taking A/ Dvantage of thermal resistance through the constant current source putting the temperature into voltage, and then by 24-bit high-precision A/ D converter a convenient digital signal imported into DSP.

硬件的实现是利用热敏电阻通过恒流源激发将温度值转化为电压值，经24位的高精度A/D转换器，转化为便于处理的数字信号提供给DSP。

A Design of Constant Current LED Desk Lamp Controlled by Touching

恒流源LED触摸台灯的设计

Then the control system for boring the non-cylinder pin hole of piston was developed, whose main function modules including displacement ( detection,) temperature detection for thermal deformation compensation, constant current power and ( central) control unit.

然后研制了活塞异形销孔加工控制系统，包括主控、位移检测、热变形补偿温度检测和恒流源驱动等功能模块。

Design of reactive type stepping motor chopping wave constant current division drive circuit

反应式步进电机斩波恒流细分驱动电路的设计

It was an effective method to solve the stable spray transfer in the MAG welding with constant current by utilizing the new type wire feeder. Using the wire feeder a droplet transfer model was established by employing artificial neural networks ( ANN).

采用新型的脉动送丝机构是解决恒定直流MAG焊稳定射滴过渡的有效途径，应用该机构采用人工神经元网络建立了熔滴过渡模型。

The PCB, used constant current technique, provides stable output current to reduce the debility and guarantee its service life.

灯板使用恒流技术，提供稳定的输出电流，减小衰弱，保证LED的使用寿命。