contact adhesive的例句大全

A one-component contact adhesive based on modified bromoinated butyl rubber for seaming EPDM roofing membrane was developed.

研制了一种单组分三元乙丙防水片材接缝用接触型胶粘剂。

A one-component contact adhesive based on modified bromoinated rubber for seaming EPDM roofing membrane was developed.

研制了一种 单组分 三元乙丙防水片材接缝用接触型胶粘剂.

Influence of Contact Pressure Distribution of Amphibious Tracklayer to Adhesive Force under NonLinear Cutting Model

非线性剪切模型下履带车辆接地比压分布对附着力的影响

The wear mechanism of cast iron-spraying molybdenum is that the transfer particles come into being in contact surface. The transfer particles plough grooves and cracks on the surface after work hardening. The embedded particles tear the surface and become grooves after adhesive.

铸铁-喷钼配对副的磨损机理为先在接触表面产生转移粒子，加工硬化后在表面犁耕出犁沟和裂纹，同时镶嵌进磨损表面的粒子与基体黏着，撕裂后使表面形成犁沟。

Tabor number, adhesion parameter and elastic theory of microscale adhesive contact

Tabor数、粘着数与微尺度粘着弹性接触理论

The plug-in contact can only be fixed in place using fabric adhesive tape.

只能使用织物胶带将插入式触点安装到位。

The results showed that the remaining adhesive on the surface of the steel sheet increases the film resistance, and consequently the total contact resistance between steel sheets rises.

研究结果显示，预压后残留于钢板表面的胶粘剂形成的胶层膜电阻会使得钢板间接触电阻增大。

The semi-bright Ag-RE ( silver-rare earth) composite deposits have the properties of higher hardness and wear resistance, greater adhesive strength, higher tarnish resistance, as well as lower porosity and lower contact resistance than pure silver plating layers.

这种银&稀土（Ag-RE）复合镀层比镀银层硬度高、耐磨，结合力和抗变色性能强，而且孔隙率和接触电阻都较低。

After the removal of the subendothelium, numerous contact platelets, adhesive platelets, spreading platelets and a few platelet-aggregates could be seen.

当内皮细胞剥脱后，内皮下层可见大量接触型、粘合型、铺展型血小板和少量血小板聚集体。

The results indicate that contact area and surface adhesive force will be reduced with the decrease of fractal dimension. Furthermore, when fractal dimension is between 1.45 and 1.55, the wear ratio is the minimum. 3.

结果表明，降低表面分形维数可以减小接触面积，同时减小表面粘附力；当分形维数介于1.45和1.55之间时，磨损率最小。

A biopack tribology testing system was used to study the effects of chemical components of polyurethane, connecting stiffness between rough surface and a sensor, contact angles on the adhesive properties of polyurethane to rough surfaces.

用生物摩擦学实验系统研究聚氨酯材料的化学成分、试样连接刚度、试样间初始接触角等在不同法向载荷的粘着性能。

Testing method for adhesion of bonded fabric Adhesive elastic interaction of micro punch pre-contact

粘接布的粘附力测定法微冲头的微观粘附力及预接触变形分析

Assuming that the yield pressure and the local adhesive friction coefficient are independent on the contact spot and equal to the average values in the plastic contact regimes, the total adhesive friction coefficient is given by simple formulae.

假设屈服压力及局部粘着摩擦系数不依赖于接触斑点且等于塑性接触区中的平均值，则总的粘着摩擦系数可用简单的表达式描述。

Utilizing molecular dynamics and finite element coupling method, a two dimensional adhesive sliding contact problem between a rigid cylinder and textured surface is investigated.

采用分子动力学与有限元耦合的多尺度方法，求解二维刚性圆柱表面压头与弹性纹理表面的纳观粘着滑动接触问题。