corner radius的例句大全

The friction behaviors in the flanges area and die corner radius area during the variable forming speed/ forming loading stamping process are studied by flat plate friction test and stretch bending friction test.

为此，针对拉深成形，分别采用平板滑动摩擦实验和拉弯摩擦实验，研究了变速/变载条件下板料在法兰处和凹模圆角处的摩擦行为。

The influence of the corner radius on the impact resistance of diamond film coated tools is studied through the interrupted turning test. It is proposed that properly increasing the corner radius can effectively improve the impact resistance of diamond film coated tools.

通过断续车削试验研究了刀尖圆弧半径对金刚石薄膜涂层刀具耐冲击性的影响，指出适当增大刀尖圆弧半径可有效提高金刚石薄膜涂层刀具的耐冲击性。

The numerical simulation results show that when the round corner radius, the deviation angle and the roughness are 1 μ m, 1 ° and 40 nm, the corresponding loss is 1.7 dB, 0.7 dB and 1 dB respectively.

当圆角半径、槽面倾斜角和粗糙度分别为1μm、1°和40nm时，相应产生的损耗为1.7dB、0.7dB和1dB。

An optimum combination of forming parameters of expanding-ratio, diameter of sectorial die and corner radius of die rim is concluded from a functional relation between roundness error of cross-section and forming parameters for the process of mechanical expanding of large diameter line pipe in the paper.

针对大直径管线钢管机械扩径工艺，得到了以最终制品形状精度（横断面圆度误差）为优化目标的扩径率、模具直径和模具边缘圆角半径等成形参数的最优组合。

Influence of Corner Radius on Impact Resistance of Diamond Film Coated Tools

刀尖圆弧半径对金刚石薄膜涂层刀具耐冲击性的影响

Double corner curb. Corner radius can be specified.

双拐角路缘. 可指定拐角的半径.

the influence of bend radius inside the rectangle pole coil against dimension of the bend corner part is discussed.

阐述了矩形磁极线圈弯曲半径对弯角部位形状尺寸的影响。

the results indicated that the mainly strain at the die corner was shearing strain and the existence of the oblique radius widened the deforming area.

结果表明，在模具转角处主要发生剪切变形；通道内侧倒角的存在使变形区宽化。

By optimizing the radius of rounded corner at the root of thread and the structure of screw nut, and by changing the diameter of the root of thread, the concentrated stress was reduced, and stress distribution was improved for higher fatigue strength of the screw bolt.

通过优化螺栓螺纹根部圆角半径和螺母结构、改变螺纹根部直径的方法，缓解螺纹根部的应力集中，改善应力分布，实现提高螺栓疲劳强度的目的。