cutout的例句大全

Our tiring-room can be checked, whether is he his board piece in had had what operation, it is cutout post, buy supported to perhaps add elite.

我们后台可以查，他是否在他的板块里有过什么操作，是删帖了、置顶了或者加精华了。

Research on the Method of Stress Analysis around Cutout in Laminated Structure

复合材料叠层结构孔口附近应力分析方法研究

The value of the limit load reduced with the cutout rate increase.

通过研究发现：在相同加强条件下，极限载荷随着开孔率得增加而减小。

Multiple relay protection with high voltage ─── the design of phase cutout protective circuit

高压综合继电保护装置&断相保护电路设计与实现

The Effect of Cutout on Natural Frequencies of Thin Plate

开孔对薄板振动频率的影响

Cutout Analysis of Composite Structures Part ⅰ: The Cutout Problems in Composite Plates

复合材料结构开孔分析第一部分：板类开孔问题

Study on natural frequency of plain woven fabric laminate with cutout

含孔损伤平面编织层合板固有频率研究

Analysis of the Cutout Law and Tendency in the Lower Reaches of the Yellow River

黄河下游断流规律及其趋势研究

Dual Reciprocity Boundary Element Method for Flexural Waves in Thin Plate With Cutout

含孔薄板弯曲波动的双互易边界元法

Protection of Fusible Cutout for US Type Package Transformer

美式箱式变压器熔断器的保护

The General Solution for the Stress Problem of Circular Cylindrical Shells with an Arbitrary Cutout

圆柱壳开孔的应力集中&非圆孔问题的一般解

On the Stress Concentration in Thick Cylindrical Shells with an Arbitrary Cutout

厚壁圆柱壳开孔应力集中问题的复变函数解法

On the Dynamic Stress Concentrations in Orthotropic Plates with an Arbitrary Cutout

各向异性平板开孔动应力集中问题的研究

Elastic unstability and reinforcement of ship structural plate with cutout

船舶构件腹板开孔的弹性失稳与加强效果

Welds containing defects exceeding that amount shall be cutout and replaced.

应切除并更换含缺陷超过该值的焊缝。

Photoshop Commonly Used Methods and Techniques Cutout

Photoshop中常用的抠图方法和技巧

The Round Window Cutout in Two Dimensional Drawings

二维图形的圆形窗口裁剪

Study on Hull Girder Strength of Ship and Stress Analysis of a Simply Supported Plate with a Cutout

船舶总强度分析及开孔板受力特性研究

Discuss methods of cutout computer graphics in Photoshop

浅议Photoshop中的抠图方法

Technical ways to increase unit cutout of light supported caving face in relatively thinner thick seam

较薄厚煤层轻放工作面提高单产技术途径