cutter point的例句大全

Aimed at point and cutter point of handwork program calculating problem, a new method is presented.

针对手工编程中的基点和刀位点的计算问题给出了一种新的求解方法.

Having found out the transition point on the gear slotting cutter, the authors discuss several cases of interference when the internal meshing gears are slotted and give the checking formulae.

本文在确定了插齿刀过渡点的基础上，讨论内齿轮副插齿加工时的几种干涉情况，并给出了校验公式。

The QX straight conjugate internal gear pump is a new type of hydraulically driving element. The calculation of tooth profile, the limiting point of meshing, the designing process of slotting cutter were introduced.

介绍了一种新型液压动力元件&QX型直线共轭内啮合齿轮泵的齿廓曲线计算、专用插齿刀具设计方法，分析了齿廓啮合极限点。

The orange ball on the screen is a pivot point that allows the transfer engraver to direct the specific cutter paths.

屏幕上的橙色球是一个支点，允许转让的具体指导雕刻刀具路径。

In this paper the C cutter radius compensation has been accomplished. It needs to compute the intersection point of two motion lines;

本课题要实现的刀具补偿为C型刀具补偿，由于C型刀具补偿需要计算两段运动轨迹的相交点，所以必须提前提取下一段运动段代码。

Solution on Base Point and Cutter Position Point of Handwork Program in NC Technique

数控技术中手工编程的基点和刀位点坐标求解方法

Side rake angle is determined by rake angle and back declination angle and the position of the cutting point in the cutter.

齿前角、侧转角及切削齿齿刃上工作点的位置，决定了该点工作时的前倾角。

it pointed out that the design of gear cutter should greatly increase the tooth point arc so as to reduce the stress concentration to increase the force of tooth root.

指出通过计算作出图形，可分析出滚刀齿顶圆弧的设计是否合理。

The Research of Cutter Location Point Arithmetic in Manufacturing Lamb Socket Mould

数控加工假肢接受腔阳模刀位点算法的研究

Asymmetric dual-angle milling cutter used to point chutes, and inclined spiral groove, level surface.

不对称双角铣刀用来铣削角度槽 、 斜面及螺旋沟 、 台阶面.

Two formulas of compound shaper cutter are ob-tained. They are used to calculate the pitch pressure angle of chamfer involute and radius of circle on which chamfer involute starting point lies, and to check the tooth root slot width.

得到了复合插齿刀倒角渐开线分度圆压力角，倒角渐开线起始点所在圆半径的设计公式及插齿刀齿根槽宽的验算公式；

Mathematical models for continuity check, probe path check, adding lead-ins and point density and cutter direction adjustment are established respectively by analyzing the requirements for every steps of pre-proccessing to achieve, also the algorithm flow charts are given.

通过分析磨削加工前处理各个步骤所要达到的目标要求，分别建立了连续性检查、探针路径检查、添加引入线、点密度调整以及刀具方向调整的数学模型并给出了算法流程图。