deflections的例句大全

test method for deflections with a falling-weight-type impulse load device

落重型脉冲负荷装置挠曲的试验方法

the determination of vertical deflections based on gps leveling observations at discrete points

用GPS水准法测定单点垂线偏差

force and piv local flow measurements were conducted in a low speed wind tunnel to study the effectiveness of serrated gurney flap at different deflections.

用低速风洞测力试验和襟翼处绕流的PIV测量试验研究锯齿形格尼襟翼在不同偏角下的增升效益。

We may use the plane stress analysis for determining deflections in the midplane of the beam.

我们可以用平面压力的分析方法来确立梁中间面的挠度.

Vertical elements carry sufficient load through cantilever action to produce cantilever deflections equal to arch deflections.

垂直杆件则借悬臂作用产生和拱挠度相等的悬臂挠度,来承担足够的荷载.

The effects of deflections are evaluated during the process of calibrating the balance.

变形影响是在天平校准的过程中测量的.

They observed the deflections of the particles by allowing them to fall on a fluorescent screen.

他们让粒子落在荧光屏上以观察他们的偏移.

The slender members which result may permit deflections which are functionally or visually unacceptable.

这样得到的细长构件,可能产生不符合功能要求和视觉要求的挠度.

This paper also introduces the stress losses of post-bar and deflections of beams before and anchorage.

文中还介绍了双预应力混凝土梁变形的特点和有关预应力损失问题.

Equations are established based on the principle of deflections consistency.

根据板簧变形协调原理,导出相应的方程.

Measuring crank deflections for per cylinder, in accordance with diesel works requirements and criterions.

主机各缸臂距差均在主机厂要求的范围内,符合规范的要求.

Since asphaltic concrete materials are temperature dependent in nature, measured deflections and hence the structural capacity of pavement vary with temperature.

由于沥青混凝土材料强度的温度依赖性，弯沉以至路面结构承载能力都随温度而变化。

Calculation and Analysis on the Deflections of Crankshaft under Dynamic Balancing Test

曲轴动平衡试验中的挠曲变形计算及分析

Based on the Reissner Mindlin type global displacement field and predictor corrector method, the deflections and transverse shear stresses were investigated for laminated composite cylindrical shells under mechanical load.

本文根据Reissner Mindlin型的全局位移场（一阶和三阶），应用有限元预测&修正法，数值计算和分析了机械载荷作用下复合材料层合圆柱壳的挠度和横向剪应力。

The manners, that is parallel or series connection, in which the dashpot is attached to Iwan model depend on the condition that the loads applied to the model are forces or deflections.

它和模型的连接方式，即取串联或并联的连接方式，决定于模型的荷载是力还是变位。