formation temperature的例句大全

High temperature parison out of the die begins to cool after contacting air during parison formation, which results in parison temperature gradients in axial and radical direction.

型坯成型中高温的型坯在离开口模后与空气接触冷却，导致型坯在轴向方向和径向方向存在温度梯度。

Normal tertiary oil recovery isn ′ t fit for Zhongyuan oilfield with high reservoir temperature and formation water salinity.

鉴于中原油田地层温度高、地层水矿化度高，常规三次采油技术难以适应。

The formation of soil moisture inversion is related with the state of soil temperature and moisture, the intensity of atmospheric humidity inversion, and the atmospheric thermodynamic stability.

土壤逆湿的形成与土壤温度状态、大气逆湿强度和大气稳定度都有关。

The critical micelle concentrations of SDS in aqueous solution at different temperature and urea concentration were obtained by conductance and the thermodynamic parameters dependence of temperature and urea concentration for the formation of SDS micelle were also obtained by the thermodynamics of micellar formation. 2.

通过水溶液中SDS电导的测定，得到不同温度不同尿素浓度下SDS水溶液的临界胶束浓度，根据胶束形成的热力学特性，得到SDS胶束形成的热力学常数与温度、尿素浓度之间的关系。

Based on the field test parameters and thermodynamic theory, this article calculates pressure, temperature and hydrate formation during transformation process.

本文根据现场调研生产参数和热力学理论，计算状态变换过程中的压力、温度关系和水合物生成。

The thermokinetics of formation reaction was studied at different temperature by liquid-phase reaction.

改变反应温度，研究了配合物的液相生成反应的热力学性质。

The higher milling temperature and the longer milling time are favorable to the formation of the ternary alloy powders.

提高反应球磨温度、延长球磨时间有利于三元合金产物的形成；延长球磨时间，形成的三元合金产物中磨球的成分增加；

High extractant concentration and high temperature are helpless in the formation of the third phase.

萃取剂浓度和体系温度升高不利于出现第3相，且萃取剂富集在第3相中；

Research on the Formation and Degradation of Inosinic 5'-Monophosphate in Chicken Muscle under Different Storage Temperature

不同贮藏条件下鸡肉肌苷酸生成与降解规律的研究

Evolution of organic materials is divided into four stages according to total hydrocarbons/ organic carbon; the threshold depth and temperature for oil and gas formation are supposed to be at 2,200 meters and 90 ℃.

同时主要依据总烃/有机碳，将有机质演化划分为四个阶段，确定了油、气生成的起始门限：深度2200米，温度90℃。

Traffic load and temperature load are two main factors accounting for its formation and propagation.

交通荷载和温度荷载是导致反射裂缝形成和扩展的主要因素。

Formation cause of thermal infrared high temperature belt along Honghe fault and its relation to earthquakes

红河断裂热红外高温条带的成因及其与地震活动性关系的探讨

Sea Ice Impacts on the Formation of Muddy Tidal Flats in the Temperature Zone& A Case Study of Jiangsu Coast

海冰对温带淤泥质潮滩发育的影响&以江苏弶港潮滩为例

Based on these data the effect of polymerization temperature on decay of catalyst activity, the chain transfer reaction and the formation of the active center were discussed.

根据测得的数据，讨论了温度在活性衰减、链转移反应和活性中心生成中的作用。

The formation of ozonation by-products was connected with the concentration of bromine ions, the kinds and concentrations of the organics in the water, pH value, the dosage of ozone, temperature, and alkalinity.

副产物的形成与溴离子浓度、水中有机物种类和浓度、pH值、臭氧投加量、温度和碱度等因素有关。

Experimental Investigation on Effects of Kerosene Temperature on Detonation Wave Formation

煤油温度对于爆震波形成影响的实验研究

The experimental results show that the curing temperature of the modified MDPES for making the composite mainly depend on both the reaction of network formation and the cleavage of the ether linkages in BE.

研究表明，选择BE/MDPES的固化温度时，必须同时考虑网络的形成反应和BE中醚键的断裂反应。

An advanced Al_3Ti-TiB_2-SiC/ Al-13% Si Composite was fabricated by compound technologies of in-situ reaction& liquid stirring. Thermodynamics of formation of reinforcing phases in composite was calculated in theory and analyzed, and temperature of reaction in-situ was validated by DTA test.

对利用原位反应与高剪切液态搅拌复合专利技术制备的Al3Ti TiB2SiC/Al13%Si复合材料的增强相的形成热力学进行了理论计算和分析，并采用差热分析法（DTA）进行了试验验证。

The gadolinium doped and lutetium doped borosilicate glass system were prepared by the technique of high-temperature melting at different temperature and the formation range of glass are experimentally obtained, respectively. The thermal stability and broadband emission characteristics of the prepared glasses were discussed.

制备了一系列的钆硼硅酸盐玻璃和镥硼硅酸盐玻璃，分别确定了这两类玻璃系统的玻璃形成范围，讨论了玻璃的热稳定性及宽带发射特性。

Higher pressure and temperature favored the formation of homogenous system.

对影响均相体系形成的压力、温度、时间和剪切作用等工艺条件进行了分析。