friction heat的例句大全

Results show that the poor lubrication condition during the working of the diesel engine acts as the main reason for sinter. When the lubricating oil is insufficient, friction heat rises, which causes the crankshaft and the bearing shell bear very high thermal load.

研究结果表明，烧瓦的原因主要是润滑条件不良，摩擦热量增多，曲轴与轴瓦都承受很高的热负荷，最终导致烧瓦。

the problem of the friction between the piston groups and the cylinder wall was studied and its friction heat model was established.

研究了活塞组与气缸套壁面的摩擦问题，建立了活塞组与气缸套壁面的摩擦产热模型；

Friction heat was important to tribological behavior of NBR.

摩擦热对丁腈橡胶的摩擦磨耗规律具有直接的影响.

Feasibility Analysis on Usage of Friction Heat to Transport Crude Oil in Buried Hot Oil Pipeline

埋地热油管道利用摩擦热进行原油输送的可行性分析

Friction heat calculation of floating piston pin bearings of diesel engines

柴油机浮动式活塞销轴承的发热计算

It was concentrated on processes of crack surfaces slip, crack growth and friction heating of closed crack driven by sheer stress, heat conduction, decomposition of solid propellant and its interaction with the gas-phase product.

研究在压应力与剪切应力作用下闭合裂纹滑移、扩展、摩擦生热、热扩散、推进剂热分解及与气相产物相互作用。

Drum roller which break in half along the axis, accompanied with severe burning of the phenomenon of friction heat, cause the entire production line shutdown, loss greatly.

其中鼓形滚子沿轴线断裂成两半，并伴随有严重的摩擦生热灼烧的情况。导致整条生产线停产，损失巨大。

When the lathe motorized spindle operates, its thermal loss of motor and friction heat of bearings will increase the whole system temperature.

高速车削电主轴运行中，电机的损耗发热和轴承的摩擦发热使系统温度升高。

Isotropic pyrolytic graphite is gradually used in aero-engine turbine shaft seals dues to its light weight, high thermal conductivity, low coefficient of friction, low liner expansible coefficient, high heat resistance, excellent thermal shock resistance and good chemical stability.

各向同性热解石墨因为其重量轻、高导热率、低摩擦系数、低线膨胀系数、高耐热性、高耐热震性、良好的化学稳定性等优点逐渐被应用于航空发动机涡轮轴密封件当中。

The creation and diffusion mechanism of heat, the measure and analysis of the temperature of wear surface under high speed dry sliding were analyzed. The influence of thermal results on tribological performance of friction pair was discussed.

分析了在高速滑动干摩擦过程中热的产生和扩散机理、摩擦温度的测定与分析，讨论了摩擦热效应对配副材料摩擦磨损性能的影晌。

Rub up and down briskly for one minute, creating heat from the friction.

轻快地向上和向下擦一分钟，创造摩擦热量从。

Mechanical motion disappears in friction and reappears as heat.

机械运动会因摩擦而消失，并再现为热。

Finally, Scheme is confirmed the most friction from heat dilatability is calculated.

通过计算，分析接头在符合导流、结构支撑功能的基础上，确定最优方案，并计算热膨胀性引起的最大摩擦力，满足设计要求。

Two metal surfaces rubBing together cause friction and heat; But if they are separated by a thin film of oil, the friction and heat are reduced.

两个金属面相擦，就要产生摩擦和热；但如果在它们之间抹上薄薄的一层油，就可以减少摩擦，降低热度。

Phenolic aldehyde resin used in anti-friction materials is modified with boron compound to improve its heat-resisting and wear-resisting performances.

用硼化合物对酚醛树脂进行改性，使硼元素以结合键形式存在于酚醛树脂中，提高酚醛树脂的耐热性，应用于摩擦材料，使其摩擦系数稳定，磨损率低。

The relative sliding velocity, the coefficient of friction and frictional heat flux between contact tooth flanks are calculated.

研究了啮合过程中轮齿的相对滑动速度和齿面摩擦因数以及摩擦热流密度的计算方法；

The friction coefficient and normal force have a great influence on the heat resource.

摩擦系数与法向正压力对于热源产生的热量大小有着很大的影响。

The factors causing the mechanical lines between die and aluminium alloys section under the heat and dry friction condition are discovered through practical observation and experimental analyses.

通过生产观察与实验分析找出了模具与铝合金型材摩擦副间在热状态干摩擦条件下产生机械纹的因素。

Piston must be able to withstand the heat from the burning air-fuel mixture, plus the heat generated by friction.

活塞必须能够承受住空气燃料混合燃烧时所释放出来的热量，以及在此过程中摩擦所生成的热量。

An experimental system was set up for investigating the flow friction and heat transfer characteristics in microchannels.

通过实验系统研究了硅基正弦波纹微通道中的流动阻力和强化换热特性。