gap flux的例句大全

Effect of Ring Material on Air Gap Flux of Permanent Magnet Machine

紧圈材料对永磁电机气隙磁通的影响

Mathematical Models of 12-phase Synchronous Machine with Air Gap Flux-oriented Control

采用气隙磁链定向控制的十二相同步电动机数学模型

The analytic calculation formulas for air-gap flux density and detent force due to end effects were derived.

导出了气隙磁密及由于边缘效应所引起的磁阻力的解析计算公式。

Influencing Factor Analysis of PMSM Air Gap Flux Density

永磁同步电机气隙磁密影响因素的分析

In particular, approximate expressions for the air gap flux and the airgap flux density are derived.

特别是, 近似表达式气隙磁通和气隙磁通密度的计算公式.

But WVF can only control the air-gap flux and can not adjust the torque.

调压调频控制只控制了电机的气隙磁通,而不能调节转矩.

The influence of slots moving and the commutating current on the air-gap flux of PM starter motor

电枢齿槽运动和换向电流对永磁起动机气隙磁通的影响

The influences of core sectional area, gap, axis shift, axis deflection to max magnetic flux density, coupling coefficient and transmission efficiency is analyzed, the regularities are got.

主要分析了非接触式变压器的磁芯截面积、磁芯间隙、磁芯轴线偏移以及磁芯轴线偏摆对系统最大磁通密度、耦合系数和传输效率的影响规律。

Investigation in Agglomerative Flux for Narrow-Gap Submerged Arc Welding of Cr-Mo Steel

铬钼钢窄间隙埋弧焊用烧结焊剂的研制

At the same time, the carbon flux flowed toward glycerol-3-phosphate ( G3P) to form glycerol from dihydroxyacetone phosphate ( DHAP) and glyceraldehydes-3-phosphate ( GAP) node increases 67.2%, while the carbon flux flowed toward TCA cycle decreases 26.9%.

从节点磷酸二羟丙酮和三磷酸甘油醛流向三磷酸甘油合成甘油的碳流量增加了67.2%，而流向三梭酸（TCA）循环的流量减少了26.9%。

realization of ultra-narrow gap welding with flux strips constraining arc

焊剂带约束电弧超窄间隙焊接的实现

An air-gap-flux observer used for air-gap-flux-orient control of 12-phase synchronous motor speed regulation system is obtained.

进一步推导得到了气隙磁链定向控制12相同步电动机调速系统的气隙 磁链观测器.

It shows that Power Magnetic Bearing with improvement has a higher magnetic flux density of air-gap through theoretical arithmetic and electromagnetic field analysis.

通过理论计算和电磁场有限元分析表明：改进后的动力磁轴承具有较高的气隙磁密，意味着提高了动力磁轴承的输出功率。

The welding machine is composed of ESAB-AZ arc welding power supply, a welding dolly, narrow-gap welding head, wheel stand, channeling prevention device, rotational earth-wire clip, 3 dimensional welding bench and an automatic welding flux withdrawer.

该专机由ESAB&A2埋弧焊电源和焊接小车、窄间隙焊头、滚轮架、防窜装置、旋转地线夹、三维焊接工作台、焊剂自动回收机组成。

Results show that the highest place of flux density is superposition of armature and guide sleeve end of pole piece, and the changing for pole piece inside diameter unilateral gap settle on the thrust characteristic.

通过可视化模拟和分析得知，磁通密度最高的地方是衔铁与极靴导套端重叠部分，极靴内径单侧间隙的变化对吸力起决定作用。

Due to larger equivalent air-gap and flux leakage of slotless permanent magnet linear synchronous motor ( PMLSM), magnetizing current method was adopted to obtain equivalent current density of permanent magnet, however armature current was considered in practice.

建立无槽式永磁直线同步电动机分层解析模型，由于电机等效气隙较长、漏磁较大，采用磁化电流法等效永磁体电流密度，电枢电流按实际情况考虑。

Operating at small gap width would maximize the flux.

另外，小的气隙宽度可得到大的膜通量。

TIG has been used for root pass, self-shielded flux-core FCAW for fill and gap in light of the characteristics on the construction site.

根据现场施工特点，采用钨极氩弧焊根焊、自保护药芯焊丝半自动焊填充、盖面。

Constricted Arc by Flux Strips Applied to Ultra-narrow Gap Welding

焊剂带约束电弧用于超窄间隙的焊接

Calculation of Air Gap Magnetic Flux Density and Back EMF Waveform

Air（初三适用）无刷直流电机中气隙磁密及电势波形的计算