gel coat的例句大全

the preparation and characteristics of the tm-36 #gel coat resin for spray up and hand lay-up are introduced in this paper.

本文介绍了TM-36#手湖喷涂两用型胶衣树脂的研制及性能。

the gel coat resin viscosity more accessible, good-flow, high thixotropy.

该胶衣树脂粘度较适中，流平性好，触变性高。

the gel coat resin viscosity small flow-good, high thixotropy.

该胶衣树脂粘度较小，流平性好，触变性高。

the resin is not only suitable for spray up and hand lay-up processes, but also a good kind of gel coat resin for mould making.

实际试用结果表明，该树脂不仅适用于喷涂、手糊成型工艺要求，而且是良好的模具胶衣树脂。

gel coat affects a lot on open mould molding frp parts.

在玻璃钢开模成型工艺中，胶衣对制品的性能有很大影响。

research of a weatherproof flame retardant gel coat resin

耐候性阻燃胶衣树脂的研究

Gel coat resin can be applied to high performance sanitary ware, bathroom component and marine topcoat.

产品可用于高性能的卫生洁具、浴室部件以及海上用品的胶衣被复。

spray gel coat resin that is of weather resistance, corrosion prevention, fadeless, uvioresistance and of good performance.

内外表面采用耐老化、耐腐蚀、不褪色、抗紫外线性能优良的胶衣树脂喷涂。

this applies just as much to cases where there is no structural damage, but where a gel coat needs to be replaced.

这种情况多数用在没有结构破坏但胶衣需要替换的修理中。

But it is not appropriate for phosphoric acid electrolyte owing to its highly corrosive attack on the oxide film. Finally, PZT nanotubes were synthesized using a sol-gel method together with spin-coating technique in through-hole PAA templates. The effect of the PZT sol concentration was studied.

最后，采用溶胶-凝胶旋转涂敷法在一次恒流高场阳极氧化法制备的通孔PAA模板中合成PZT纳米管，研究了溶胶浓度对其形貌的影响。

In this paper, TiO2 films were synthesized by dip-coating technique on glass slides with a self-made tiras machine, on the basis of the nonionic surfactant template theory and sol-gel theory.

本论文以非离子型表面活性剂模板理论及溶胶-凝胶理论为基础，利用自制的提拉机，通过浸渍-提拉的方法于载玻片上制备TiO2薄膜。

In this case, ITO precursor slurries were prepared by organic and inorganic sol-gel methods using metal indium and tin salt as raw materials. A dip-coating process was performed to deposit ITO precursor slurry on the substrate.

本文以锡的无机盐和金属铟为原料，分别通过有机法和无机法制备出ITO前驱物浆料，采用浸渍提拉法在玻璃基片上涂覆薄膜并经过热处理得到ITO薄膜样品。

TiO2/ SnO2 composite film prepared by the sol-gel method was deposited on a slide glass substrate by dip-coating method at low temperature.

采用溶胶-凝胶法常温合成含有一定晶型的TiO2溶胶和SnO2溶胶，使用浸渍提拉法在普通载玻片上制备出TiO2/SnO2复合膜。

TiO2 precursor film was prepared, employing sol-gel method and dip-coating method, using Tetra Butyl Titanate and absolute ethyl alcohol as raw material and Ni ( NO3) 2 as Ni2+ source, with a coating speed of 2~ 3mm/ min.

以钛酸四丁酯和无水乙醇为原料，加硝酸镍引入镍离子，采用溶胶凝胶法和浸渍提拉法在玻璃表面施涂膜层，镀膜速度控制在2~3mm/min。

The sol-gel dip-coating method was used to nuke NASICON thin films for the firsttime The results and existing problems were described.

首次介绍采用溶凝胶浸泡涂布法制备NASICON薄膜，简要介绍实验结果和存在的问题。

Coat of paint, gel, lamination, gel, contain cloud effect.

漆皮 、 凝胶 、 层压 、 硅胶, 带有云彩效果.

The canopy is gel-coated and ready for your own custom paint job.

冠凝胶,并准备为自己的风俗画工作.

The present paper deals with the preparation of surfactant ( deoxycholic sodium and tetrabutylammonium bromide mixture) coat bonded to silica gel with alkyls as well as its application to the separation of chiral enantiomers.

研究脱氧胆酸钠和溴化四丁铵的混合态表面活性剂涂层烷基键合硅胶（ODS）固定相的制备和它在手性对映体分离中的应用。