glass temperature的例句大全

By studying the several important control indicators of glass powder, such as crystallization, glass temperature, the optimum proportion of glass powder is made certain.

通过研究玻璃粉的几个重要控制指标如析晶、玻璃化温度，确定了玻璃粉的最佳配比。

The results show that the glass temperature of polyester fiber treated with CWL has obviously dropped, therefore the plasticization effect is confirmed.

结果表明：助剂CWL处理后涤纶纤维的玻璃化温度明显降低，说明助剂CWL对涤纶纤维起到了增塑作用；

Homogeneous bridging groups always raise the glass temperature.

同类桥联基因总是提高玻璃化温度.

The second layer was pellucid glass temperature control, and the control strategy was self-tuning fuzzy control.

第二层为澄清部温度控制，控制策略为自校正模糊控制算法；

A artificial neural network model concerning window glass temperature distribution and camera resolution is constituted, building a three-layer BP network model in which windows glass three point temperature value is considered as network input, camera resolution as network output.

建立了窗口的热光学性能神经网络模型。把镜面上点的温度作为网络的输入，光学分辨力作为网络的输出，建立一个三层BP网络。

Heterogeneous bridging groups can raise the glass temperature according to their chemical composition.

不同类桥联基团根据它们的化学组成能提高玻璃化温度.

the results of analysis to copolymers with differential scanning calorimeter indicated that, with increasing the content of soft monomer, the glass temperature of copolymer lowered.

DSC结果表明，随聚合体系中软单体含量增加，共聚物的玻璃化温度降低。

Preparation of High Temperature Resistant and Low Expansion Coefficient Glass

耐高温低膨胀玻璃的研制

A stirrer mounted at neck can improve the heat distribution of molten glass and drop the temperature in conditioning zone;

卡脖处安装搅拌装置可提高玻璃液的热均匀性，并能降低冷却部温度；

The temperature correction of type CGR-1477 carbon glass thermometer working in magnetic field

CGR-1477型碳玻璃温度计对磁场的修正

The effects on the adhesion strength of HDPE/ APS-glass assembly were studied at the different plasma treatment time, lamination temperature and lamination time. The relation between the hydrophilicity and the adhesion of HDPE film was investigated.

研究不同等离子体处理时间、成层温度和成层时间对HDPE/APS玻璃粘接效果的影响，考察HDPE膜的亲水性与其粘接性之间的关系，寻找HDPE/APS玻璃最佳粘接条件。

Its glass transition temperature and weight loss temperature was higher than 320 ℃ and 435 ℃, respectively.

玻璃化转变温度大于320℃，5%热失重温度大于435℃。

Research on Construction Temperature and Cracks of Concrete During Engineering Construction of Glass Factory

玻璃工厂工程建设中混凝土的施工温度与裂缝研究

The influence of glass transition temperature and homogeneity of polymer membrane on the responding feature of electrodes were also discussed.

本文还讨论了聚合物的玻璃化转变温度和膜的均匀性对电极性能的影响。

Temperature Prediction for the Float Glass Ribbon in Lehr Based on BP Neural Network

BP神经网络模型对浮法退火窑内玻璃温度的预测

It is shown that the glass-melting temperature, the homogenizing time, and the water content in the environment during the glass-melting and the fiber-drawing process are very important technological parameters in order to reduce the scattering loss.

结果表明，选择适当的熔化温度和均化时间，玻璃熔化和光纤拉制时环境中低的水含量是制得的损耗氟锆酸盐玻璃光纤的关键；

Investigated is the temperature schedule at which PbO SrO BaO Nb 2O 5 ferroelectric glass ceramics forms.

主要对PbO-SrO-BaO-Nb2O5系铁电性微晶玻璃形成的温度制度作了研究。

Experiment Research on Temperature Response of Faraday Effect in Paramagnetic Terbium Glass

顺磁性铽玻璃法拉第效应温度特性实验研究

Effect of Glass Phase on High Temperature Stability of Thick Films in Tungsten System

钨系厚膜材料中玻璃相对高温稳定性的影响

A few strain rate peaks, which are associated with the glass transition and multistep crystallization, were observed in the temperature strain rate curve.

在应变速率与温度的关系曲线中，观测到了与玻璃转变和晶化过程相联系的多个应变速率峰。