groove depth的例句大全

The patterns etched are of high resolution, and the groove depth and groove wall angle can be controlled with less surface stress.

具有极高的分辨率，能够控制槽深和槽壁角度，表面应力小。

the optimization model of sealing ability for a bushing helical seal is presented. in this model, the maximum value of sealing coefficient is objective function, and the relative groove depth, the relative groove width and helical angle are designed variables.

以密封系数最大为优化目标函数，考虑了相对槽深、相对槽宽和螺旋角等约束条件，建立了螺套式螺旋密封封液能力优化的数学模型。

On the choice of groove parameters, the influences of groove parameters ( such as groove depth, groove opening angle and groove root radius) on the groove bottom stress concentration extent were analyzed by finite element method.

在切口参数的选择上，本文使用有限元方法分析了切口深度、切口张开角度及切口根部圆角半径等对切口处应力集中程度的影响。

Method for Controlling Groove Depth and Duty Cycle of Rectangular Photoresist Gratings

一种控制矩形光刻胶光栅槽深和占宽比的方法

The result shows that the groove depth and duty cycle error of phase mask must be controlled within the range of| Δ h| < 38nm and| Δ f| < 0.11 respectively in order to make the zero order diffraction efficiency less than 5%.

分析表明，为使零级衍射效率小于5%，相位掩模的刻槽深度和占空比制作误差必须控制在｜Δh｜＜38nm和｜Δf｜＜0.11的范围内。

The tire noise increased as the groove depth and number increased;

随着轮胎沟槽深度的增大和沟槽数目的增加，轮胎噪声增大；

an easy tool for measuring the depth of sealing groove is devised.

介绍一种测量抽油杆减振器柱塞密封槽深度的测量工具.

Because of shallow groove and slide clearance have comparable depth and height, the impedance of shallow groove match the impedance of slide clearance. The throttle works well and the load carrying capacity and stiffness were increased.

由于浅槽与导轨间隙具有同量级的深度和高度，所以气流在槽内与导轨间隙内所受阻抗相匹配，因此产生节流效果，提高了承载力和刚度。

Normal methods are restrained to measure the depth of narrow and shallow groove.

在窄浅槽的深度测量方面，常用的测量方法受到很多的限制。

the influences of the location, width and depth of the stress relief groove on the stress relief and sub's strength are analyzed as well.

评价分析了减应力区开口位置、宽度和深度等参数对应力释放效果和配合接头强度的影响。

Calculation of a Spiral Groove Thrust Bearing of Varying Depth with Boundary Element Method

变深度螺旋槽止推轴承的边界元法计算