hammer test的例句大全

12t drop hammer test machine research on energy efficiency and arrangement of power system of hydraulic crusher with dropping hammer

12t落锤试验台液压落锤式碎石机动力系统配置及能量效率

The causes of the fractures and breaks after the drop hammer test are analyzed and discussed.

对落锤断裂的原因进行分析讨论。

Drop Hammer Concrete Crusher 12t Drop hammer test machine

落锤式水泥路面破碎机12t落锤试验台

Using the Maxi Te hammer test system, the acceleration-tested system has been experimented, and the correctness of the design has been tested.

最后利用马希特锤对加速度测试系统进行了测试实验，验证了设计方案的正确性。

Environmental test methods have high and low temperature test, impact test, temperature resistant and corrosion test, test, test, and dustproof sealing test, vibration test, impulse hammer and crash test, transport test, constant acceleration test, life test ( durability).

环境试验方法有高低温试验、温度冲击试验、耐潮及防腐试验、防霉试验、防尘试验、密封试验、振动试验、冲击和碰撞试验、运输试验、恒加速试验、寿命（耐久性）试验等。

The design research of test installation scheme for water hammer and surge chamber

水击及调压室实验装置方案的设计研究

Based on the test results of 30 specimens of concrete interfacial roughness former by chipping with hammer and by splitting, a roughness instrument for measuring concrete interface is put forward, which is simple and cheep.

通过30组混凝土立方体试块，分别对人工凿毛及劈拉试验试件的断开面两种类型分别采用自制量测仪法与灌砂法进行了粘结面粗糙度测试研究。

Method to confirm impact stiffness by drop hammer impact test machine

用落锤冲击试验机确定隔振器冲击刚度的新方法

Vibration parameter measure on drop hammer impact test machine

在落锤冲击试验机上进行的隔振器振动参数识别

Study of drop hammer plastic deformation at engineering vehicle FOPS impact test

工程车辆FOPS冲击试验中落锤塑性变形研究

A method to confirm impact stiffness& wave combination method by drop hammer impact test machine is introduced.

介绍一种确定隔振器冲击刚度的新方法&波形组合法。

The basic principle of simple high strain pile test method transformed from measured free fall of drop hammer is given in this paper.

给出测量自由落锤的加速度换算高应变试桩的动力的简易法的基本原理、测试操作与工程应用。

Methods of performance test for tubular diesel pile hammer

GB/T6945-1986筒式柴油打桩锤性能试验方法

Based on the steel truss bridge mode of 1 ∶ 10 scale, the identification methods of bridge structure damage detection was discussed. By finite element method and hammer pound method with Varied-Time-Base ( VTB) technology, the modal test analysis of bridge modal was done.

本文以1∶10钢桁架桥梁模型为研究对象，用有限元模型及实验模型进行局部损伤的识别，实验采用锤击法及变时基（VTB）技术对桥梁模型进行了模态分析。

The Research of the Abnormal Water Hammer Phenomenon based on the Unit 3 over Speed Test of Jiangsu Yixing Pumped Storage Power Station

江苏宜兴抽水蓄能电站3号机组过速试验异常水击现象的研究

Here is an introduction to the performance and characteristics of multi hammer, clamp plate and wheel type tamping machine and the test for its main components.

介绍了多锤夹板轮式捣固机的性能特点和主要部件的试验。

Study on equipment for drop hammer dynamic tear test

落锤式动态撕裂试验装置

lastly apply a impact hammer with different pulse width to verify the effect of the test.

最后应用不同脉冲宽度的激振锤，来验证对测试效果的影响。

Analysis on hammer weight of high strain testing to test pile capacity choice

基桩承载力高应变检测锤重的选择

The context were set in three different conditions, first, the model of impact were raised to the desired height, and then released so that the drop hammer make the gravity acceleration to impact test beam.

本文共设置了三种不同的工况，首先将落锤分别提至所需高度，然后释放使落锤在重力作用下作加速运动撞击试验梁。