heat condition的例句大全

Thermomechanical Treatment for the Automobile Steering Knuckle BRAZING OF HEAT EXCHANGERS IN AIR-CONDITIONER

汽车转向节形变热处理

This paper proposed a mathematics model for the simulation of ground-source heat pump system based on distributed parameters, including compressor, plate-type heat exchanger, thermostatic expansion valve, water and refrigerating agent thermal condition performance and performance of state matter, and so on.

本文用稳态分布参数法建立了土壤源热泵装置各部件的数学模型，包括压缩机、板式换热器、热力膨胀阀、水和制冷剂的热性和物性参数的程序化等。

The sample's backside temperature response was analyzed for various sample thickness, absorption coefficient, radiative boundary condition and heat loss.

此外，本文对试样吸收系数、辐射边界、厚度及试样表面的热损失等因素对温度响应的影响进行了对比分析。

It will through functional switch in winter that to achieve as a heat pump air-conditioners to supply heat and heat pump water heater to supply hot water.

而在冬季通过功能切换，分别实现作为热泵空调机供暖和热泵热水器供应热水的目的。

The results show that the value of recieved radiative heat flux between Low E glass and clear glass differs a lot under same condition.

结果表明：在相同条件下，Low E玻璃与普通透明玻璃所受到的辐射热流通量相差很大。

This paper briefly describes the features and the service condition related to water-level control of waste heat boiler steam drum for tilting furnace in the Guixi Smelter.

简述了贵溪冶炼厂倾动炉余热锅炉汽包水位控制的有关特点和使用情况。

The valve work condition and normal failure are studied in this paper. The heat treatment of 21-4N steel exhaust valve is related to the samdwich separated out. The samdwich affects the valve capability 21-4N steel exhaust valve fatigue fracture is caused by thermal overstress.

本文介绍了气门的工作条件、正常失效及21-4N钢排气门强化热处理与层状析出的关系，分析了层状组织对其性能影响和21-4N钢排气门过载断头失效的原因。

Optimum design and economic analysis of heat recovery air-conditioner

热回收型空调器的优化设计及经济分析

Heat Transfer in Thin Metal Film under Harmonic Thermal Boundary Condition

简谐温度边界条件下金属薄膜中的热响应

Traditionally, heat transfer coefficient is measured in the laboratory under the estimated extremely cold winter environment condition of winter cold area in accordance with Graduation and test method for thermal insulating properties of windows ( GB8484-1987).

《建筑外窗保温性能分级及其检测方法》GB8484-1987规定窗户传热系数检测在模拟严寒地区冬季条件下进行的，与夏热冬暖地区的实际使用情况有较大差别；

This conclusion is some value to reasonably choose test condition and decrease heat rate.

结论对于合理选择汽轮机真空系统严密性试验的工况，具有参考价值。

Secondly, we investigate the heat conduction in the mass-graded harmonic model with harmonic/ anharmonic on-site potential by nonequilibrium molecular dynamics simulation. The necessary condition for the appearance of thermal rectification is discussed in detail.

然后，我们利用非平衡分子动力学模拟的方法，对具有质量梯度和外部格点势的一维简谐晶格模型中的热传导进行了细致地研究，重点讨论了系统中产生热整流效应的必要条件。

Through test for beam& pillar under the condition of the abnormal heat, we propound a strengthening project.

对梁、柱受非正常高温后通过检刚，有针对性地提出加固方案。

The Model Optimization of Heat Exchanger and Refrigeration System in Air-Conditioner Digital Design

空调器数字化设计中换热器与系统模型的优化

In the condition of without seepage, this paper analyzed the heat transfer performance of ground heat exchanger at different flow velocity within tubes and obtained the ground temperature field thermal influencing radius.

针对无渗流的情况，模拟分析了不同管内流速下地埋管换热器的换热性能，得到了不同管内流速下的土壤温度场和热作用半径分布。

Based on the second law of thermodynamics, irreversible analysis of forced convective heat transfer through a duct including thermal entrance region is made on the condition of constant wall heat flux and constant wall temperature respectively.

利用热力学第二定律，分别在壁面热流恒定和壁面温度恒定两种情况下，在考虑热进口段时对管内对流换热过程进行了热力学分析。

Urban thermal environment results from many factors such as land use/ land cover, the artificial heat sources comes from energy consuming, weather condition in urbanized areas.

城市热环境是土地利用/覆盖、城市人为热、气候条件等多因素综合作用的结果。

A rectangular thermal shock and plate heat transfer model was established under the condition of thermal shock test bed and the simulation results were got, also.

建立了与热冲击试验台加热环境相适应的矩形热冲击模型和平壁热传导模型，并求得相应的解析解。

Under the immovable operating condition, this paper calculated the thermal load of heat pump drier, determined configuration of device and relevant size, and analyzed the functions of the device.

在定工况条件下对热泵干燥装置负荷进行计算，确定了系统设备的配置和相应的选型，分析了装置可实现的功能。

Analysis on the Heat Balance and Optimum Condition in the Primary Chamber of a CAO System

CAO焚烧系统一燃室热平衡及最优工况分析