heat load的例句大全

This article discusses components of a 300 MW unit coordinated control system, including the forming of actual load demand, boiler demand and heat signal, turbine master station and boiler master station.

论述菏泽电厂300MW机组协调控制系统构成，包括实际负荷指令的形成、锅炉指令与热量信号、汽轮机主控站和锅炉主控站。

At cooling-heating load aspect, utilize building thermal environment design simulation software DeST work out space load.

在冷热负荷确定方面，利用建筑热环境设计模拟工具包DeST进行了房间负荷计算。

Finally, five different load ratios of water-cooling vapor compression chiller and air source Heat Pump system were optimized with optimization box in MATLAB. After the optimization, the air-conditioning system's energy consumption drops obviously;

最后借助MATLAB语言中的优化程序包，对一实际水冷蒸气压缩式空调系统和空气源热泵空调系统负荷率不同的5种工况分别进行优化计算，优化后空调系统的能耗比额定能耗明显降低；

Considers the harmonic method easy and simple in use in contrast with the response factor method. But two questions require attention, i.e. the calculation of the cooling load from the steady part of radiant heat gain and the determination of harmonic order for high precision of calculation.

认为与反应系数法相比，利用谐波反应法计算空调负荷简便，但在计算中应注意辐射得热中稳定得热形成的冷负荷的计算及谐波阶数的选取问题。

This paper describes the annual energy consumption and economic assessment of air-source heat pump ( ASHP) and ground-source heat pump ( GSHP), based on hourly building load of typical house in Fuzhou.

以福州地区典型的单户住宅为实例，在全年逐时建筑负荷计算的基础上，进行空气源热泵和地源热泵的全年能耗分析，并在此基础上进行两者的经济性比较。

load optimizing distribution of main-pipeline unit involves two energy, heat and electricity.

母管制电厂中的负荷优化分配要涉及到热、电两种不同的能量；

heating with gas can reduce air pollutant emission and therefore becomes a new sort of peak load heat-source.

燃气供热可以减少污染物的排放，逐渐成为一种新的调峰热源。

if in north winter construction, but also should consider the snow load and the heat preservation maintains the facility load;

若在北方的冬季施工，还应考虑雪荷载和保温养护设施荷载；

study on the relation between heat shock proteins and heat stress of marcher with load in dry-heat desert

沙漠热环境负重行军者血浆热休克蛋白与热应激的关系

the results show that as the load increased, the combustion ignition delay was decreased, and cylinder temperature, pressure, heat release rate, soot and no emissions are increased.

结果表明，随着负荷的增加，燃烧滞燃期缩短，缸内温度、压力、放热率、Soot和NO排放均增加。

two kinds of fuzzy relationships in load adjustment of heat pump system

热泵负荷调节中的两类模糊关系

Because of the shape of the block , the RED EYE focuses the heat to the load.

因为炉头砖的形状, 红眼把热量聚焦在加热体上.

The cause of externally applied pipe load to brazed aluminum heat exchanger and the necessity of calculating allowable pipe load are analyzing.

分析了板翅式换热器封头接管外载荷产生的原因和进行许用接管载荷计算的必要性。

Calculation Method of Allowable External Pipe Load Applied to Brazed Aluminum Heat Exchanger Header and Its Application

板翅式换热器封头许用接管外载荷计算方法及应用

Research on the method for calculating allowable external pipe load applied to brazed aluminum heat exchanger based on limit analyse

基于极限分析的铝板翅式换热器封头许用接管载荷计算方法研究

The ASHRAE Modified BIN method can be used to simulate building load. Simplified static simulation methods can be used to calculate energy consumption of heat source equipment.

提出了这类系统能耗分析的思路和计算方法，在建筑负荷计算方面，可以采用改良温频法，在设备模拟方面，可以使用稳态的简化模拟法。

Research on ascertaining heating load of house-hold and heat metering system

分户计量供暖系统热负荷确定方法探讨

May also act according to requests Canada to suppose the ventilator, the heat gun, the air conditioner forced draft fan, the air-conditioner, the excess load display, the intercom and so on.

还可根据要求加设风扇、热风器、冷风机、空调器、超负荷指示器、对讲机等。

This time, design of steam cooler and drain cooler tubing system has had many changes, that compares with long since, the more rational structure, so much the better heat transfer efficiency. Research on the Partial Load Property of Heater with Drain Cooler

此次，在蒸、疏冷的管系设计中，与以往相比有较大变化，使结构更为合理，传热效果更佳。带疏水冷却器的回热加热器变工况特性研究

Annual temperature distribution of underground soil is analyzed concretely at the load rate of 70%, and we find that temperature is not increase entirely, but the overlapping result of release and absorb heat.

通过具体分析70%负荷率下全年地下土壤温度场的分布，发现温度场不是整体升高，而是温度波逐渐向远边界处传递的结果。