heating value的例句大全

The value of temperature change was calculated by Thermodynamic equation. The three films all appear the maximum heating temperature change near their curie points.

热力学公式计算铁电薄膜电热温变值，三种薄膜在各自的居里点附近均出现了最大电热温变值。

It has some value the design and management the obtainment and heating system in winter.

对于深井水源热泵的取水系统设计、冬季制热运行的管理有一定参考价值.

The Method to Calculation The Calorific Value of Heating Steam And Calorimeter

过热蒸汽热量的计算及仪表

Scanning power in adjustable base-wide implementation of scanning, the base value range is 0-400V, scan range is 0-800V. Hot cathode heated power to 100A current heating power supply.

扫描电源在可调基值范围内实现扫描，基值范围为0-400V，扫描范围为0-800V。热阴极加热电源为100A恒流加热电源。

methods: the factors such as drug concentration, ph value, amount of active charcoal added, temperature of solution, and time of heating which influence active charcoal adsorbing tinidazole were studied using uniform design.

方法：通过均匀设计法对影响活性炭吸附替硝唑的影响因素如药物浓度、pH值、加炭量、温度和加热时间等进行考察。

Thermal Value Theory and Its Application to Energy-Saving for Continuous Heating Furnace

热价值理论及其在加热炉节能中的应用

The Measurement for Thermal Value of Gas in Heating Furnace and the Combustion Control System

加热炉煤气热值测量及燃烧控制系统

The accuracy of the measurement system was evaluated by comparing the rectal mercury thermometer reading with the machine measured value right after the completion of heating. Results The deviation between the values read by rectal mercury thermometer and the machine was 0.1 0.7?

结果对测温系统准确性的研究结果显示，用水银温度计在停止治疗后测量与机测温度对比误差为0.1～0.7℃。

therefore, a study on floor heating material industry on its distribution channels model has a high application value and practical significance.

因此，对地热建材行业分销渠道模式的研究具有较高的应用价值和现实意义。

This text has introduced the test method and principle for test heat elastic modulus E value of 20# steel according to needs of practical production and plan of sample and heating temperature and result of test.

介绍了根据实际生产需要测试20钢的高温弹性模量E值的方法和依据的原理、试件的设计、加热温度设定和试验结果。

The numerical value method of metal heating in continuous rolling mill heating furnace

推钢式连续加热炉金属加热数值计算

In order to improve productiveness, the liquid temperature should be maken arrive predetermine value as short time as impossible, and controlling accuracy should be ensured at the same time. For the purpose, an optimum scheme of dynamic heating in all process is presented.

在确保恒温精度的同时，为了在尽可能短的时间内使液体温度达到预定的温度，以提高工作效率，提出了全程动态加热方案。

Regulating pH value of the circulating hot water up to 10.0 during heating period can significantly reduce the oxygen absorption rate in heating pipeline.

供暖期内，调整循环热水的酸碱度，使循环热水的pH值达到10.0，可使供热管道内主要发生的吸氧腐蚀速率明显下降。

Determined Optimum Critical Value of Investment with Nuclear Heating System at Low Temperature

低温核供热系统最佳投资临界值的确定

When heating rate is less than the critical value, no abnormal growth occurs.

加热速率小于临界值时，则不会出现异常晶粒长大现象。

Method: To measure the chroma value ( Lab) of two groups of silicone elastomer samples colored by oil paint: heating vulcanized at 80 ℃, 90 minutes and room temperature vulcanized at 23 ℃, 24 hours, and calculate Δ E value between the samples.

方法：测定80℃热固化，固化时间90min与室温固化23℃，固化时间24h两组油画颜料着色的硅橡胶试样的色度值（Lab），并计算试样间的色差值（ΔE）。

The daily heat load and hourly heating load of building of Qingdao in heating season is conducted with the usage of DeST-H energy consumption simulation software. The typical day hourly value of solar radiation of Qingdao is calculated based on the solar radiation law.

利用能耗模拟软件计算了青岛地区一栋建筑的供暖季日总负荷和典型日逐时负荷；根据太阳辐射的规律，得出了青岛地区典型日太阳辐射量的逐时变化。

The experimental results showed that chlorine ion content disturbs COD value drastically first, the second is the petroleum content. The suspended substance content and heating time have little influence on the result.

实验结果表明，Cl-含量对COD值的影响最大，其次为石油类含量，而加热回流时间和悬浮物含量对测定结果的影响不大。