heating的例句大全

After technical test it has expressed that such internal heating devices are suitable for the isothermal heating of big forgings.

通过工艺试验表明，内加热装置适用于大型锻件的等温加热。

The heat-treatment technology with medium frequency induction heating for driving wheel of crawler tractor is analyzed, and proved being feasible through technical test, data analyzing and trial installation.

摘要本文分析了履带拖拉机驱动轮中频感应加热的热处理工艺，从工艺试验、数据分析和装机试验几个方面验证了该工艺的可行性。

The article primary introduces composing of HT-7 Neutral Beam Injection ( NBI) system, then mainly analyzes gas target thickness, that is pressure distribution of neutralizer gas cell, one of factors which affect heating efficiency of NBI.

本文首先介绍了HT-7中性束注入（NBI）加热系统的组成，然后对影响中性束注入加热效率因素之一的气体靶厚度即中性化室的压力分布进行了重点分析。

Heating Study on the End Zone of Stator Core for Asynchronized Generators

异步化发电机定子端部发热的研究

Meanwhile, from technical classification, actual application, construction method and other aspects this heating system is mainly introduced and its advantages and development prospects are discussed in detail.

从低温地板辐射采暖概况、技术分类、实际应用等方面进行了介绍，分析了它的优点，并对其发展前景进行了展望。

Heating measurement of the Tsinghua University in Beijing, the city's Technical Test Center detection, integrity unit launched Declaration, the Chinese premier assured the radiator market brands.

北京清华大学供热压检测，唐山市技术监督局检测中心检测，中国诚信宣言发起单位，中国散热器市场首选放心品牌。

Technical Characteristics of Radiant Floor Heating in Foreign Countries

国外地板辐射供暖技术特点

Experimental Analysis and Technical Reform of A Chain Heating Furnace

链式加热炉的试验分析和技术改进

Technical regulation for heating, ventilation and air conditioning designing of thermal power plant

火力发电厂，汽力发电厂，热电站火力发电厂采暖通风与空气调节设计技术规定

This paper deals with the problems of ionization proportion, ion density and heating work piece on glow discharge.

从理论上研究了辉光放电时的离化率、正离子浓度、工件的加热问题。

Application of constant flow three-way valves in heating system

供暖系统定流量三通调节阀的应用研究

The thermal instability of sulforaphane, with increasing temperature or heating time will gradually decompose.

莱菔硫烷对热不稳定，随温度升高或加热时间的延长会逐渐分解。

Analysis of Indoor Dynamic Thermal Environment and Thermal Comfort on Heating Room

供暖房间动态热环境及热舒适分析

The solid solid state reaction of 2,2 ′ ( p phenylenedimethylenethio) diacetic acid with nickel acetate tetrahydrate at low heating temperature

2，2'－对苯二甲硫基二乙酸与醋酸镍在低热温度下的固－固相反应

Dehydration of tetrahydrate copper methanesulfonate in different heating rates ( 5,10,15,20 ℃/ min) were studied and dehydration kinetics was discussed by the programmed temperature method.

对不同升温速率（5,10,15,20℃/min）下Cu（CH3SO3）2.4H2O的脱水过程进行了非等温脱水动力学研究。

The method can calculate flux assignment and node pressure of heating network under different conditions by counting non-linear equation group according to network inherent parameter, solve the calculation problem of asymmetric network as the result of fault and remedy the shortcoming of the method for planar network.

该方法可根据网络的固有参数通过求解非线性方程组给出不同工况下管网的流量分配和节点压力，还可解决故障导致的管网水力不对称问题，从而弥补了平面网方法的不足。

It also discusses the effect of the temperature on the viscosity, flow and cure properties for the plastics and the rheologic curve how to show the theologic behaviour of DMC in the course of heating and shearing.

讨论了温度对塑料的粘度、流动和固化的关系，以及流变特性曲线如何显示聚酯模塑料在加温剪切下的流变行为。

Theoretical Study on Atmospheric Boundary Layer and the Interaction with Free Atmosphere over Local Heating

局地热源上大气边界层及其与自由大气相互作用的理论研究

After three heating forms of theoretical cycle were compared, in accordance with the working specialities of internal combustion engines, it was confirmed that performance of the constant pressure heating cycle is optimal within temperature and pressure restraints.

基于内燃机的工作特点，比较理论循环的三种加热方式，证明了温压约束下等压加热循环性能最优。

The results showed that, when the evaporation temperature increase, the heat load, the material evaporation and condensation capacity, the system heating coefficient of performance COP, compressor theoretical power consumption and the theoretical heating medium flow rate all increased.

实验结果表明，系统热负荷、物料蒸发量和冷凝量、系统制热系数COP、压缩机理论耗功量和理论热媒流量均随着料液蒸发温度的升高而增大。