high ion的例句大全

335 alkalescent ion exchange resin was used in the exchange adsorption of high concentration of copper ion in wastewater from phthalocyanine green production.

采用335弱碱性阴离子交换树脂交换吸附酞菁绿废水中高含量的铜离子。

In this article, TiO_2 films are prepared on glass substrate by ion beam assistant thermal oxidative electron beam evaporation. Ti ( AT2) is used as the evaporated material and high purity O_2 ( 99.99%) is used as the thermal oxidative gas.

本论文采用离子束辅助反应电子束真空蒸镀法，以Ti为膜料，纯度为99.99%的O2为反应气体，通过电子束蒸发，在玻璃衬底上反应生成TiO2薄膜。

Thermal Annealing Behaviour of high dose~ ( 40) ar~+ ion implanted silicon layers

高剂量的~（40）Ar~+离子注入硅热退火行为的研究

Due to the high energy density and organic flammable electrolyte system, lithium-ion batteries may undergo thermal runaway under certain conditions, leading to unsafe events e.g. ignition, explosion when they are abused or misused.

锂离子电池因其高能量密度及采用有机易燃电解液体系，当发生误用或滥用时，在一定条件下引发热失控，会引起不安全事故。

Reversed phase ion pair high performance liquid chromatography for the analysis of sultamicillin

舒他西林的反相离子对高效液相色谱分析法

PTA plants exposure to high concentrations of acetate, bromide ion, terephthalic acid, condensed water and other corrosive media, high temperature, high pressure environment to run the equipment, the use of extremely harsh conditions.

PTA装置干燥机接触高浓度醋酸、溴离子、对苯二甲酸、凝结水等腐蚀性介质，在高温、高酸环境下运行，设备的使用条件极为苛刻。

The mixed ionic and electronic conducting ( MIEC) oxides can transport oxygen ion and electron simultaneously at high or intermediate temperatures.

离子-电子混合导电型（Mixed Ionic and Electronic Conducting，MIEC）氧化物在中高温能够同时传导氧离子和电子。

Damage Distribution in Compound Materials Induced by High Energy Ion Implantation

直接法-多次矩法联合计算高能离子注入化合物靶损伤分布

A Nonaqueous Hybrid Electrochemical Supercapacitor Based on High-voltage Li-ion Battery Cathode and Active Carbon

活性碳／高电位锂离子嵌入化合物有机系混合型超电容器

In comparison with Pt/ ion exchange resin, both conversion and selectivity of Pt/ carbon fiber catalyst are high.

Pt／活性碳毡催化剂的CTC转化率和氯仿选择性均高于Pt／离子交换树脂催化剂；

Determination of Cu and Ni in High Purity Eu_2O_3 by Ion Chromatography

离子色谱法测定高纯Eu2O3中的微量Cu和Ni

Through high rate charge and discharge, the capacity can restore to 161 mAh · g-1 ( 1C). Finally, in order to reduce the relative voltage of the material, metal ion Cr is doped.

经历了大倍率充放电后，容量能恢复到161mAh·g-1，为1C充放电的96%。最后，为了降低材料的相对电压，掺杂了金属Cr。

The SiO2 holographic blazed grating with good quality and high diffraction efficiency have been developed by reactive ion beam etching and holographic grating mask made by lensless Fourier transform holography recording.

本文报道以无透镜傅里叶全息术变换记录的全息光栅作掩膜，应用反应离子束入射角控制光栅闪耀角，选择了合适刻蚀工艺参数，制得衍射效率为67%的SiO2全息闪耀光栅。

High quality ITO transparent conductive film was prepared by reactive low voltage ion plating technique, which is different to the most common sputtering method to deposit ITO film.

溅射镀膜方法是制备ITO透明导电膜最常用也是实验研究最多的方法。

High speed steel samples were ion nitrided in a tube reactor with an auxiliary heating furnace. The change of nitriding layer thickness, surface hardness and impact strength of the sample with H 2/ N 2 ratio, temperature and time were studied.

用外加热方式在管状反应室中对高速钢试样进行离子氮化，对氮化层的厚度变化、表面硬度及冲击韧性随H2／N2、渗氮温度及时间的变化进行研究。

The spinel manganic acid lithium is promising to be cathodes for Li-ion battery, due to its relatively high energy density and low toxicity.

尖晶石型锰酸锂具有无毒、能量密度高等特点，是下一代锂离子电池最有前途的正极材料之一。

The results show that high frequency lead to high electron density and ion density in the discharge center.

实验结果表明，在高频的射频功率驱动下在放电中心的离子密度和电子密度较高。

High density spherical cathode materials for lithium ion batteries

锂离子电池高密度球形系列正极材料

The results showed that the novel fibrous materials contain carboxylic functional group with appropriate hydrazide cross-link structure. Owing to high external surface area and short transfer route, FFC-1 ion exchange fiber is provided with excellent reaction kinetic property.

结果表明：FFC-1离子交换纤维为含适量酰肼类交联键的聚羧酸（钠）型离子交换材料，外比表面积大和传质距离短是其反应动力学性能优异的主要原因。

Zr-Ni-N coextruded film is deposited on high speed steel and single crystal silicon slice by using vacuum arc deposition technique. The influences of low energy nitrogen ion beam aid deposition on coating structure, morphology and hardness of Zr-Ni-N film are studied.

采用多弧离子镀技术在高速钢和单晶硅基体上制备Zr-Ni-N复合薄膜，研究了低能氮离子束对Zr-Ni-N涂层结构、表面形貌和硬度的影响。