hot metal的例句大全

The structure optimization is ultimate approach to decreasing are and hot metal to steel ratio and energy consumption per ton crude steel.

钢铁工业结构优化是降低钢比系数，进而降低吨钢能耗的根本途径。

First-hand Experience and Second-hand Knowledge in Prediction of Silicon Content in Hot Metal Tapped from Blast Furnace

高炉铁水硅含量预测中的直接经验和间接经验

Influence on the melting process at shaft furnace with hot metal charging

部分热装铁水对竖式电炉冶炼工艺的影响

A method combining temporal difference method with neural network model is applied to predict the sulfur content of the hot metal.

将时差方法与人工神经元网络方法有机地结合起来，提出了一种在高炉铁水含硫量预报中的应用策略。

He had seen them shape the knives from white-hot metal, temper them in cold water, then hone them to glistening sharpness.

他见到过他们把白热的金属做成刀，在冷水里淬火，然后再把它们磨得锋利锃亮。

Based on thermodynamic function of hot metal predesulphurizing reaction and desulphurizing reaction rate, the conditions beneficial to hot metal predesulphurization was analyzed.

根据铁水预脱硫反应的热力学函数和脱硫反应速率，分析了有利于铁水预脱硫的条件。

The thermodynamic study of hot metal dephosphorization fluxes containing BOF slag

转炉渣用于铁水预处理脱磷剂的热力学分析

Theoretical analysis to reduce temperature drop of hot metal in transportation

减少铁水和钢水出炉后温降的理论分析

The hot metal is charged into BOF with some slag increasing production cycle time and cost increment.

对炼钢来说，入炉的铁水渣量大，使得冶炼周期长、消耗高。

The paper describes the functions of secondary refining ( including hot metal treatment) and puts forward some related proposals based on the future development of continuous casting for production of quality sheet steel, tin plate and silicon sheet steel in Shanghai iron and steel industry.

本文针对上海钢铁工业今后发展优质薄板、镀锡板和硅钢片钢的连铸生产，论述了炉外精炼技术所起的作用，并提出了有关建议。

Analysis of hot metal temperature drop in torpedo car

鱼雷罐铁水温降分析

Application Study in Deoxidization and Alloying of Hot Metal by Adding Aluminium-manganese-titanium Alloy

用铝锰钛合金进行脱氧合金化的应用研究

Development in technology of continuously measuring temperature of hot metal in tundish using tung sten-rhenium thermal couple

钨铼热电偶在连铸中间包钢水连续测温中的应用中间包钢水连续测温技术及钨铼热电偶主要相关技术的发展

Experiment had proved feasible that two different metal ceramic rods used as thermal couple electrodes were immersed directly into hot metal to measure temperature continuously.

采用两种不同组成的金属陶瓷棒作为测温热电偶，置于钢液中进行连续测温，实验证明是可行的。

DEVELOPMENT IN TECHNOLOGY OF CONTINUOUSLY MEASURING TEMPERATURE OF HOT METAL IN TUNDISH USING TUNG STEN-RHENIUM THERMAL COUPLE Application Research of Nonmetal Thermoelectric Couple in High Temperature Detection

中间包钢水连续测温技术及钨铼热电偶主要相关技术的发展非金属热电偶在高温探测中的应用研究

Using K-Na modification for hot metal during smelting resulted in better thermal impact resistance and thermal fatigue resistance.

在熔炼过程中，铁水采用K－Na变质剂处理，可获得良好的耐热冲击和耐热疲劳性能。

It is proved by controllable metal experimental instrument: thermoelectric potential field exists in cooling hot metal of cast iron, which is point electrical potential field, and its life is approximately 0 05 ￣ 3 58s.

用金属型可控实验仪证实：进行冷却的铸造铁水内部存在着温差电势场，且为点电势场，其寿命约为0.05～3.58s。

The BF hot metal at KISC is oversaturated with carbon and its average temperature fall reaches 1.5 ℃/ min during transportation, hence, a large quantity of kish is inevitably deposited.

昆钢高炉铁水在出铁时含碳量达饱和，运输过程中平均温降为1.5℃／min，产生大量片状石墨粉尘是必然的。

Neural Network Predicting Model for Hot Metal Desulphurization by Mg Containing Desulphurizer

镁基脱硫的人工神经网络预测模型

Si content in hot metal was lower, kO was higher.

铁水硅含量越低，kO越大。