ignition heat的例句大全

Just only then went against the ignition heat sun, returns to the company from the customer, felt that oneself quickly became "Beijing roast duck".

刚刚才顶着火热太阳，从客户那儿回到公司，感觉自己都快成“北京烤鸭”了。

Premixed combustion shows better Performance, including extended stable range 、 simple ignition 、 lower heat loss and more powerful Thrust output in catalytic experiments.

实验研究发现，铂催化环境下，微喷管内的预混燃烧表现出了良好的燃烧性能，包括较为宽阔的稳燃范围，良好的点火性能、较低的散热损失以及较高的推力输出等。

benzoic acid was used as the combustion adjuvant in determining the incendiary heat of high ignition point material, which can make the successful rate which access to 100% of once fired and the sample fully burns, without affecting the determining result.

通过实验研究了用苯甲酸作助燃剂测定高燃点物质的引燃方法，该法能使实验一次点火成功率达到100%，样品燃烧完全且对测定结果无影响。

When the LPG alternating ratio is smaller, the ignition delay of pre-mixing model is longer, and the peak cylinder pressure and heat release rate are higher than those of mixing injection model, and their corresponding crank angles retard.

LPG替代率较小时，预混进气方式与混合喷射方式相比滞燃期较长，最高爆发压力和最大燃烧放热率较低，对应的曲轴转角滞后；

The effective approaches for improving ignition performance are to improve quality of fuel sprays, to sustain optimum spark time, to keep the electric pole distance a little more than quenching distance and to pre-heat starting fuel etc.

提高雾化质量，保持最佳火花持续时间，电极间距稍大于冷熄距离。以及对起动燃油加温等，都是改善点火性能的有效途径。

Then with the action of the ignition device, a new balance of heat transfer and chemical reaction was built in the surface of the base bleed charge.

在点火具火焰的持续作用下，底排药剂反应表面建立起新的传热与化学反应平衡；

The heat radiation in cylinder of a high speed light load compression ignition engine is measured using a heat radiation sensor.

在一台小型高速单缸压燃式发动机上，利用商用辐射传感器测量了缸内辐射传热量。

besides, there are also other anticorrosive and heat-resistant products with low sulfur and free of ignition loss offered.

公司以柔性石墨线，盘根为基础研发了具有超低硫、抗锈蚀、耐高温、无烧失等特性的高精尖密封产品。

calculation and analysis of the heat release rate in homogeneous charge compression ignition natural gas engine

均质压燃式天然气内燃机燃烧放热率的计算

the results show that as the load increased, the combustion ignition delay was decreased, and cylinder temperature, pressure, heat release rate, soot and no emissions are increased.

结果表明，随着负荷的增加，燃烧滞燃期缩短，缸内温度、压力、放热率、Soot和NO排放均增加。

According to the heat release rate, the reaction pathway to ignition of sample alkane is analyzed.

利用新型的绝热量热仪研究了两种典型烷烃的自加热过程,采取了增大样品容器体积和加压的方法,得到了正庚烷和正十六烷的初始反应温度 、 大升温速率和最大升温速率对应的温度.

A heat recovery system, utilizing the hot air from the draft fan at the first zone of a draft strand cooler for ignition, heat preservation and sintering is introduced.

本文介绍一个用抽风带冷机第一段的热风进行点火、保温和烧结的余热利用系统。

Isolate from any source of heat or ignition.

与热源和明火隔绝.

The results show that, with the increase of DME proportion, inlet pressure increases, but the ignition delays, the peak in-cylinder pressure and heat release rate, peak in-cylinder temperature and peak pressure rise rate decrease, and their phases retard.

研究发现，采用同一喷嘴时，随着燃料中二甲醚比例的增加，发动机进气压力增加，着火延迟，缸内压力峰值、放热率峰值、最高缸内温度、压力升高率峰值降低，其相位延后。

The effects of radiant heat flux, moisture content and species on the ignition behavior were analyzed.

测定了材料的表面温度和质量损失速率,并分析了辐射热能流率 、 含水率和材料种类对材料着火特性的影响.