in compression的例句大全

analyzing and verifying of the forced cylinder in compression refuse collector

压缩式垃圾车油缸受力分析及校核

combustion characteristics and soot formation in compression ignition. gasoline engine fueled with homogeneous mixture

均质混合气压燃汽油机燃烧特性和碳烟的生成

Experimental study of "ShaQima Framework" planting concrete in compression resistance and planting

沙琪玛骨架绿化混凝土抗压与植草试验研究

Results The strain of long screw compared with short ones, is respectively 16%, 41%, 56%, 41% lesser in compression, anterior flection, posterior extension and luteral flection;

结果长螺钉的应变比短螺钉应变在压缩、前屈、后伸、侧屈分别小16%、41%、56%、41%；

in compression zone bolt force of end-plate connections distribut triangularly, when designing calculating the force model can be referred .

端板连接受压区螺栓受力呈三角形分布，设计时可参考本文受力模型计算。

rubber properties determination in compression or shear; (yerzley mechanical oscillograph)

橡胶压缩或剪切性能的测定（扬子尼机械示波器）

However, the deformation research in tension is seldom, the constitutive relation in compression and tension and failure criteria is not perfect too.

而在拉伸条件下岩石的变形研究则很少，压缩与拉伸下岩石的本构关系及破坏准则也不完善。

It is pointed out that the intermodulation distortion and gain compression of SIT are mainly caused by the nonlinearity of transconductance G_m, then by those of gate-source capacitance C_ ( gs) and drain conductance G_d in order.

指出引起SIT互调失真和增益压缩的主要原因是跨导G m的非线性，其次是栅源电容C（gs）的非线性变化和漏电导G d的非线性变化的作用。

Method for determination of the modulus of elasticity in compression perpendicular to grain of wood Research of Elastic Modulus of Mould Pressing Bamboo Processing Fragment Plate

GB/T1943-1991木材横纹抗压弹性模量测定方法竹加工碎料模压代木板材的弹性模量研究

This probably explains why it is used a lot in compression programs like ZIP or ARJ.

这可能解释了为什麽这是用了大量的压缩程序,压缩或压缩.

In compression test of rock loading in a constant rate of deformation way will undoubtedly lead to non synchronism between deformation and load response.

在岩石压缩试验中，按等变形速率加值，势必造成变形和荷载响应的不同步，即一个匀速而另一个则出现加速或减速现象；

research on modified coefficient of slenderness ratio of angle member in compression

受压角钢杆件长细比修正系数研究

experimental and modeling study of dimethyl ether combustion in compression ignition engine

二甲醚发动机燃烧特性的试验与数值模拟研究

auto ignition and combustion simulation of dme as oxygenated clean fuel in compression ignition engine

DME发动机着火与燃烧过程的数值模拟研究

The structure is that steel tube in the upper section, plain concrete-filled steel tube in the middle section, and concrete filled steel tube column reinforced in compression and tension area in the bottom section.

这种结构形式是从底部到顶部依次为在受压区和受拉区配筋的钢管混凝土、钢管素混凝土、空钢管，截面从下到上递减。

The emphasis of the study is on the effects of hidden weld present or absent and through brace in compression or tension on the failure mode and ultimate capacity of overlap joints.

重点考察了内隐蔽处焊接/不焊和被搭接管受拉/压对搭接节点破坏模式和极限承载力的影响；

The experimental and analytical results showed that the function of shallow water shock waves to concrete structure was involved in compression and tension of stress wave in the concrete structure.

研究表明：浅层水中爆炸冲击波对混凝土结构的作用体现在冲击压缩和拉伸两个方面。

Adopting Volterra-series, we analyzed the intermodulation distortion and gain compression behaviors of a SIT microwave power amplifier, in which three main nonlinear sources are included.

采用Volterra级数法，分析了包含三种主要非线性源的SIT微波功放的互调失真和增益压缩特性。

Correlation between pressure and time during the changes of spinal evoked potential and cauda equina in compression

脊髓诱发电位潜伏期改变与马尾神经慢性受压过程中压力和时间因素的相关性

An investigation of squish air motion in compression ignition engines

压燃式发动机中挤流运动的研究