initial strain的例句大全

According to the theory of equivalent time, creep as a function of equivalent time is expressed. By fitting experimental data, parameters of creep in equivalent time field are obtained; initial strain implicit solution of elastic creep equation in equivalent time field is derived.

根据等效时间理论，将徐变表示为等效时间的函数，通过拟合试验数据，得出等效时间域弹性模量和徐变度公式的计算参数，推导了等效时间域的弹性徐变方程的初应变隐式解法。

Using the analysis method of shrinkage and creep based on initial strain, This thesis fitted the shrink strain and the creep coefficient function with uniform exponential function model and find a way to get the recursion formulae of shrinkage and creep.

按照初应变法计算收缩徐变的原理，将04规范收缩应变和徐变系数的计算表达式拟合成统一的指数函数，得出收缩徐变递推计算公式。

The composite exhibited a tensile elongation of 250% at the initial strain rate of 8.9 × 10-4 s-1 at 833K.

研究表明：在温度为833K、初始应变速率为8.9×10-4s-1的拉伸变形条件下，其伸长率为250%；

Boundary type integral formulation of domain variables for three dimensional initial strain problems

三维初应变问题中区域变量的边界型积分公式

The results showed: three does of LD laser affected the filaments morphology, the length of filament and thread pitch and helix numbers were variety compare to initial strain.

结果表明：三个辐照时间都对藻丝形态产生影响，使藻丝长、螺旋数、螺旋长发生变化；

The influence of errors is simulated and analysed with numerical methods to verify that the initial stage of the stress-strain curve of the concrete can be described according to the specimen stain and the output bar stress.

利用数值模拟分析了误差影响程度，同时验证了用混凝土试样应变和透射杆应力得到应力-应变曲线初始段的可行性。

Three mathematical models including heat conduction model, cure kinetics model and strain model of the in-situ modeling process are built and initial and boundary conditions are given.

本文介绍热缠绕工艺的原理，建立热缠绕过程的热传导模型、固化动力学模型和应变模型，并给出求解所需的初始条件和边界条件。

Abrasion and mechanical properties test of concrete have shown that the degree of abrasion dependent on initial abrasion ratio, flexural strength and limit strain.

从混凝土磨蚀和力学性能试验得知，水工混凝土的磨蚀程度依赖于混凝土的初始磨损率，抗拉强度和极限拉伸变形值。

the relationship between the tensile stress and the tensile strain at the initial of a tension test has been experimentally determined and analyzed.

本文对电流变液的直流高压电场作用下，小应变范围内的拉伸应力应变过程进行了测试和分析。

These initial results indicate that flavoring not only saves money by reducing the number of wasted ( spit out) doses, but also reduces the strain of being in an unfamiliar hospital environment.

这些初期的研究结果表明，调味料不仅通过减少药物剂量的浪费（被吐出来）来省钱，而且也缓解了患者在医院这个陌生环境中的紧张情绪。

initial talking about the temperature compensation of strain gange load cell

应变片式传感器的温度补偿浅谈

mid-point incremental method and initial stress method are used to reflect the nonlinear of the material's stress and strain.

用中点增量法结合初应力法反映筑坝材料的应力应变非线性，计算时模拟坝体施工加载过程。

once the material parameters d, g and the parameters of duncan-chang model at initial state were given, the stress-strain relation of sands at randomly disturbed state could be predicted by the newly developed modified model.

在给定砂土材料参数d、g以及初始状态的Duncan-Chang模型参数的基础上，可通过本文修正模型预测任意扰动度下的砂土应力-应变关系。

Casing, cement and formation plane strain mechanical model are established, considering casing with initial ovality.

针对套管的不同初始椭圆度建立了套管 、 水泥环、地层平面应变力学模型.

Study on Dentification Ability of Inbred Strain Mice Tooth Germs Implanted into Oral Submucosa and Alveolar Process AIM: To analyze the distribution of initial stress around screw implant.

近交系小鼠牙胚同种异体移植至口腔粘膜下或牙槽骨内成牙能力的研究目的：分析螺旋形种植体植入下颌骨后骨界面初始应力的分布。

Based on the results, some special properties are systematically analyzed: ( 1) the influence of initial consolidation on stress-strain curve;

通过试验成果系统分析可得：（1）初始固结度对应力–应变关系的影响；

Through the simulations experiments with different initial velocity, we analyse the impact of strain rate on tensile properties, fracture characteristics and fragment number of expanding ring expansion spherical shell.

并通过不同初始速度下圆球壳膨胀碎裂的数值模拟实验，以分析应变率对膨胀球壳冲击拉伸力学性能、碎裂特性和碎片数的影响。

The influences of the kind, the volume fraction and the relative hardness of the second phase and of plastic strain ε in steel as well as of initial surface roughness R_0 on the surface roughening behaviour in free forming are investigated.

研究了塑性变形量ε、钢中第二相的种类、数量和相对硬度比及初始表面粗糙度R0对自由成型表面粗糙化行为的影响。

The tensile impact experimental results show that the initial elastic modulus and unstable strain of PE fibre bundles are temperature and strain-rate dependent, except for the failure stress of PE fibre bundles.

实验结果表明：PE纤维束的初始弹性模量和失稳应变具有一定的温度和应变率相关性，但是破坏应力变化不大。

The pipeline steel with strain-based design is usually characterized by high initial work hardening rate, good ductility, and low yield stress to tensile strength ratio.

抗大变形管线钢就是基于应变设计的方法得到的具有连续屈服、较低的屈强比、较高的加工硬化指数以及均匀塑性变形延伸率等特性的管线钢。