initial temperature的例句大全

Upper incipient lethal temperature of short term thermal shock of two species of copepods ( 2) Initial temperature of catalyst bed is wholly too high.

两种桡足类短期热冲击的高起始致死温度值（2）提高起始反应温度使催化剂床层温度整体过高导致飞温。

Calculation method of initial nucleation temperature of phases during rapid solidification by continuous cooling of multi-step reaction

连续冷却多阶段快速凝固过程起始形核温度的计算

The heat transfer in continuous casting of Tin was calculated with this model, it was found that temperature of initial solidification area was varied periodically along with mold oscillation.

在此基础上，模拟了结晶器振动条件下的锡液初始凝固传热行为，发现锡连铸中，初始凝固区域温度随结晶器振动而发生周期性变化。

The delayed supercritical process of nuclear reactor with temperature feedback and initial power while inserting small step reactivity(ρ_0 < β) is investigated.

对输入小阶跃反应性（ρ0

The heat exchange method for cooling motion simulator based on initial ventilating cooling method is presented in this paper. The flow field and temperature field in two different motion simulators are simulated using CFD method.

文章在运动模拟器初始通风冷却温度控制方案的基础上，提出了风扇换热器组件冷却方案，并采用CFD模拟两种方案下模拟器内部流场和温度场分布。

The surface grain size and thickness of scale vary with temperature, and the initial wear loss increases with increasing grain size, and same tendency is observed for the total wear loss vs the thickness of scale.

膜表面晶粒大小和厚度随着温度而变化，膜初速磨损量和总磨损量随着成膜温度的变化分别与表面晶粒大小和膜厚相对应；

In order to verify the mathematical model, experiments were carried out on a small-scale caster. Thermocouples column were adopted to measure the temperature of initial solidification area.

同时，为验证数值模拟结果的正确性，文中设计了实验室的小型连铸实验，并以锡为模拟介质，采用热电偶序列对初始凝固区域温度进行测量。

The change of the atmosphere temperature and the initial time of pipeline shutdown which affect the safety margin of pipeline shutdown is considered in the calculation first time.

计算过程考虑了大气温度变化和起始停输时间点对安全停输时间的影响。

The results of calculation indicate that the safety margin of pipeline shutdown relates not only to the product and the atmosphere temperature, but also to the initial time of pipeline shutdown.

计算结果表明：安全停输时间不仅与油品温度、大气温度有关，而且还与起始停输时间点有关；

The effects of factors such as reaction temperature and the composition of initial aqueous phase solution etc, on the yields of uranium(ⅳ) and nitrous acid is investigated.

研究了反应温度、原始水相溶液组成等因素对铀（Ⅳ）产额和亚硝酸生成量的影响。

A long-term storage test under constant temperature of 3 ℃ was carried out to undiapause Trichogramma dendrolimi of six stages of growth including young larvae, middle larvae, old larvae, prepupa, initial pupa, middle pupa.

在3℃恒温条件下，对非滞育的松毛虫赤眼蜂的小幼虫期、幼虫中期、老熟幼虫期、预蛹期、蛹初期和蛹中期6个虫态进行了长期的贮存试验。

The experimental results showed that the excessively high temperature on rate of reaction were unfavorable to the reaction, the increase of isobutene gas pressure, stir speed and initial concentration of tertiary butyl alcohol increased reaction rate, and the decease of particle size increased reaction rate.

结果表明，过高的温度对反应产生不利影晌；增加异丁烯气体压力、提高搅拌速度及叔丁醇初始浓度能提高反应速率；

The results obtained shown that the initial decomposing temperature and maximum decomposing temperature of PU are postponed and the exothermic rate is retarded with adding the thermal stabilizer.

结果表明由于热稳定剂的加入，使PU的外推起始分解温度和最大分解温度推迟，放热速度减慢。

Delayed Supercritical Process with Temperature Feedback at Arbitary Initial Power

任意初始功率下考虑温度反馈的反应堆缓发超临界过程

It is suggested that growth temperature of the AlN buffer layer influences GaN morphology by forming different AlN seed size and density on the Si ( 111) substrate during the initial growth of the buffer layer.

进一步解释了GaN外延层表面形貌中凹坑的形成及凹坑与缓冲层生长温度的关系.结果表明，温度的高低通过影响缓冲层初始成核密度和成核尺寸来影响外延层表面形貌。

With the enhancement of loading, the initial and terminal decomposition temperature of two composites increased.

随添加量的提高，两种复合材料的起始及终止分解温度均有提高。

It was found that the gradient of concentration of the initial product and that of temperature led to interfacial tension gradient, which was responsible for the presence of spontaneous mixing near interface.

研究结果表明，界面区反应生成的初始生成物在空间上的浓度梯度及反应在界面上造成的温度梯度，引发了界面张力梯度，从而在反应界面附近引起流体运动。

But compared with PP-IFR, the initial decomposition temperature and maximum decomposition temperature of PP-IFR/ MWNTs-COOH were delayed and carbon content were also decreased.

而PP-IFR/MWNTs-COOH复合材料的初始分解温度和最大热分解温度与PP-IFR比较却延后，成炭量也下降。

The tensile impact experimental results show that the initial elastic modulus and unstable strain of PE fibre bundles are temperature and strain-rate dependent, except for the failure stress of PE fibre bundles.

实验结果表明：PE纤维束的初始弹性模量和失稳应变具有一定的温度和应变率相关性，但是破坏应力变化不大。

The effects of reaction vessel, sonic intensity, sonication time, initial concentrations of H_2O_2, solution temperature and pH on ultrasonic degradation of xylene were studied.

研究了超声波降解水中二甲苯的降解效果，详细探讨了反应容器及沸石、声强、超声时间、H2O2投加量、温度、pH值等因素对降解二甲苯的影响。